Q-Logic SANBOX2-8C/16 manual Set Config Command, Set config, Port portnumber, Ports portnumber

A – Command Line Interface	0
Set Config Command

Set Config Command

Sets switch, port, port threshold alarm, and zoning configuration parameters. The changes you make with this command are not retained when you reset or power cycle the switch unless you save them using the Config Save command. Refer to the ”Config Command” on page A-11.

Authority	Admin session and a Config Edit session
Syntax	set config
	port [port_number]
	ports [port_number]
	switch
	threshold
	zoning
Keywords	port [port_number]
	Initiates an edit session in which to change configuration parameters for the port
	number given by [port_number]. If you omit [port_number], the system begins with
	port 0 and proceeds in order through the last port. For each parameter, enter a
	new value or press the Enter key to accept the current value shown in brackets.
	Enter “q” to end the configuration for one port, or “qq” to end the configuration for
	all ports. Table A-9describes the port parameters.
	ports [port_number]
	Initiates an editing session in which to change configuration parameters for all
	ports based on the configuration for the port given by [port_number]. If you omit
	[port_number], port 0 is used. For each parameter, enter a new value or press the
	Enter key to accept the current value shown in brackets. Enter “q” to end the
	configuration. Table A-9describes the port parameters.
	Table A-9. Set Config Port Parameters
	Parameter	Description
	AdminState	Port administrative state:
		„ Online – Activates and prepares the port to send
		data. This is the default.
		„ Offline – Prevents the port from receiving signal and
		accepting a device login.
		„ Diagnostics – Prepares the port for testing and
		prevents the port from accepting a device login.
		„ Down – Disables the port by removing power from
		the port lasers.
	LinkSpeed	Transmission speed: 1-Gbps, 2-Gbps, or Auto. The
		default is Auto.
	PortType	Port type: GL, G, F, FL, Donor. The default is GL.

A-38 59022-10 A