Q-Logic SANBOX2-8C/16 manual Table A-12. Set Config Zoning Parameters

A – Command Line Interface	0
Set Config Command

zoning

Initiates an editing session in which to change switch zoning attributes. The system displays each parameter one line at a time and prompts you for a value. For each parameter, enter a new value or press the Enter key to accept the current value shown in brackets.

	Table A-12. Set Config Zoning Parameters
Parameter		Description
InteropAutoSave		Available only when the InteropMode parameter is True, this
		parameter enables (True) or disables (False) the saving of
		changes to active zone set in the switch’s permanent memory.
		Refer to ”InteropMode” on page A-42. The default is True.
		Disabling the Autosave parameter can be useful to prevent the
		propagation of zoning information when experimenting with
		different zoning schemes. However, leaving the Autosave
		parameter disabled can disrupt device configurations should a
		switch have to be reset. For this reason, the Autosave parameter
		should be enabled in a production environment.
DefaultVisibility		Enables (All) or disables (None) communication among the
		switch’s ports/devices and the fabric in the absence of an active
		zone set. The default is All.

Examples The following is an example of the Set Config Port command:

SANbox2 #> admin start

SANbox2 (admin) #> config edit

SANbox2 (admin-config) #> set config port 1

A list of attributes with formatting and current values will follow.

Enter a new value or simply press the ENTER key to accept the current value.

If you wish to terminate			this process before reaching the end of the list
press 'q' or 'Q'		and the	ENTER key to do so.
Configuring Port		Number:	1
------------------------
AdminState	(1=Online,		2=Offline, 3=Diagnostics, 4=Down)	[Online]
LinkSpeed	(1=1Gb/s, 2=2Gb/s, 3=Auto)			[Auto	]
PortType	(GL / G / F / FL / Donor)			[GL	]
SymPortName	(string, max=32 chars)			[Port1 ]
ALFairness	(True / False)			[False	]
DeviceScanEnable		(True /	False)	[True	]
ForceOfflineRSCN		(True /	False)	[False ]

A-44 59022-10 A