Quick Installation, Installing the W6-LI | Micronics instruction

Chapter 1: Quick Installation

Chapter

1

Quick Installation

We know that many experienced people prefer to read as little of the documentation as possible. If this sounds like you, here’s the short form to get up and running quickly.

STATIC!

Before handling the W6-LI, be properly grounded by using a special wrist or ankle strap, or touch a safely grounded object.

Installing the W6-LI

1.Make backup copies of your installation and configu- ration diskettes.

2.Ground yourself to prevent damaging static dis- charge, then remove the W6-LI from its packaging.

3.Configure and verify the system board’s jumper set- tings (refer to Jumper Settings in Chapter 2).

4.Install the CPU and the system memory (refer to Chapter 3).

5.Install the system board into the chassis and make all necessary case connections.

6.Install any ISA and/or PCI add-on peripherals (refer to Chapter 3).

7.Now you can connect any optional devices (refer to Chapter 3).

8.Turn the computer on and press the <F2> key when you see the screen in Figure 1.1.

W6-LI System Board Manual

9

Image 11

Micronics manual Quick Installation, Installing the W6-LI

Contents

PCI/ISA Copyright Notices Table of Contents Installing Device Drivers Glossary Index List of Figures Introduction Features IBM Software Compatibility Common Names Before You Begin Installing the W6-LI Quick Installation Power-Up Screen Static Electricity Configuring the W6-LI W6-LI System Board W6-LI System Board CPU Jumper Settings Function Settings Disable Scsi 9B Case & Peripheral Connections Introduction Installing the W6-LI ATX chassis with standard hardware System Memory Installing the W6-LI Memory Configurations Memory Bank Bank 256MB Removing DIMMs Installing the DIMMs Installing a CPU Installing a PCI Card Installing a PCI Peripheral Card Installing an ISA Card Installing an ISA Peripheral Card Installing a CD-ROM Drive W6-LI Sound Option Connecting Sound Devices Line Game PortLine Out Connecting the Scsi Option Setup Bios Setup Utility Power-Up Screen Setting the Main Screen Running the Setup Procedure Numlock Video BiosSystem Time and Date Diskette a or B Extended Memory System BiosSystem Memory Multiple-Sector Transfers Type Smart Monitoring LBA Mode ControlTransfer Mode Bit I/O Serial Port B Setting the Advanced ScreenSerial Port a Integrated PCI IDE Use MP SpecificationParallel Port Floppy Disk Controller Large Disk Access Mode Reset Configuration DataPCI Configuration Secured Setup Configuration Security Screen Set Supervisor Password Supervisor Password Submenu Set User Password Diskette Access Password on BootFixed Disk Boot Sector Power Management Power Screen Auto Suspend Timeout Standby Timeout Post Errors Boot ScreenHard Drive Boot Order Setup Prompt Floppy Check Exit Screen TheBIOSSetupUtility W6-LI System Board Manual Installing the Sound Drivers Installing Device Drivers Installing the Scsi Drivers Bios Specifications Scsi Environmental Specifications Battery Disposal Technical Support Support and Information Services Service Hours Country Appendix a Technical Information W6-LI System Board Manual Post Messages Message Possible Cause Solution Cmos Beep and Post Codes Get in Post Reg Code One beep Heads Write Sectors Size Hard Disk Drive Types Type Cylinders Heads Write Precomp Sectors Size 823 512 Appendix E Updating the System Bios Updating the System BiosPage Limited Warranty Non-Warranty Service FCC Statement DeclarationofConformity Glossary Internal Cache Cache which is built into the CPU. See Cache Small Computer System Interface Glossary ATX IndexPage