Micronics W6-LI manual Installing the DIMMs, Removing DIMMs

Chapter 3: Installing the W6-LI

Installing the DIMMs

To install the DIMMs, locate the memory banks on the system board and perform the following steps:

1.Hold the DIMM so that the notched edge is aligned with the notch on the DIMM socket (Figure 3-1).

2.Insert the DIMM at a 90 degree angle.

3.Gently push the DIMM straight down until it locks into place (past the release tabs).

Figure 3-1: Installing a 168-Pin DIMM

Removing DIMMs

To remove DIMMs, follow the steps below:

1.With both thumbs (or fingers), press the release tabs away from the socket.

2.With the DIMM free from the release tabs, lift the module up and place in an anti-static bag or package.

W6-LI System Board Manual 25