Microsoft G7VP2 manual System Health Monitor Utility, Supported Softwares

4

Supported Softwares

4.2 System Health Monitor Utility

The system board comes with a System Health Monitor utility. This utility shows the current temperature of the processor, power voltages, and CPU/Chassis fan speed.

The utility also allows you to manually set the range of the processor’s temperature, power voltages, and CPU/Chassis fan speed. If the settings/values are over or under the set range, an error message will pop-up and an alarm will sound. There are three types of sound for the three different failure alarms (temperature, voltage and fan). Refer to the Chipset Features Setup (Chapter 3) section for details.

When you hear a failure alarm, you must power off your computer and check the following: processor fan/heatsink, chassis fan and power supply. We recommend that you use the “Default Setting” which is the ideal setting that would keep the system in good working condition.

	Genesys Logic System Health Monitor (for VIA)
The time					Update w/o Save
interval for	Polling Interval:	4 Seconds		6
monitoring					Update and Save
the system	Temperature
CPU	CPU Over-Heat Temperature:		80	Celsius	User Setting
temperature
limit	CPU Hysterisis Temperature:		75	Fahrenheit	Default Setting
Current
	CPU Temperature:		29
temperature
of the CPU					Quit	When
	Voltage (V)					enabled,
	High Limit: Current Voltage: Low Limit:					this screen
					Minimize when Startup	will minimize
	3.3V Values	3.60	3.35	3.00		and display a
Output						histogram
	12V Values				Alarm when	icon after
voltage		13.20	12.91	10.80
						boot-up
limit	5V Values				CPU Over Heat
		5.50	5.08	4.50
					3.3V Abnormal	These
	Fan (RPM)				12V Abnormal	items when
					5V Abnormal	enabled will
	Low Limit:		Current Speed:			alert you in
					CPU Fan Abnormal	case of
CPU/	CPU Fan	2000		5454		detected
					Chassis Fan Abnormal
						failure
Chassis
	Chassis Fan	2000
fan speed				3287
limit

60