2.5.6 Interrupt Enable Control Function
Table 2.6: Interrupt Disable/Enable Control
DI0EN & DI1EN | Interrupt Disable/Enable Control |
|
|
0 | Disable |
|
|
1 | Enable |
|
|
The user can choose to enable or disable the interrupt function by writing its corresponding value to the interrupt disable/enable control bit in the interrupt control register, as shown in Table 2.6.
2.5.7 Interrupt Triggering Edge Control
The interrupt can be triggered by a rising edge or a falling edge of the interrupt signal, as determined by the value in the interrupt triggering edge control bit in the interrupt control register, as shown in Table 2.7.
Table 2.7: Interrupt Triggering Edge Control
DI0TE & DI1TE | Triggering edge of interrupt signal |
|
|
0 | Falling edge trigger |
|
|
1 | Rising edge trigger |
|
|
2.5.8 Interrupt Flag Bit
The interrupt flag bit is a flag indicating the status of an interrupt. It is a readable/writable bit. To find the status of the interrupt, you have to read the bit value. To clear the interrupt, you have to write “1” to this bit. This bit must first be cleared to service the next coming interrupt.
Table 2.8: Interrupt Flag Bit Values
DI0F & DI1F |
| Interrupt Status |
|
|
|
Read | 0 | No interrupt |
|
|
|
| 1 | Interrupt occur |
|
|
|
Write | 0 | Don’t care |
|
|
|
| 1 | Clear interrupt |
|
|
|
20 |
