Installation
Please refer to the installation diagram supplied with the machine.
,Furniture and fittings installed near the machine must be of a commercial standard, able to withstand the effects of steam.
Installation options
–Free-standing
–
furniture or in a suitable space. The
space must be at least 35 7/16" (90 cm) wide and 29 7/16" (70 cm) deep.
–Undercounter
The machine can be installed under a continuous counter or sink drain.
The niche must be at least: Width 35 7/16" (90 cm) Depth 29 7/16" (75 cm) Height 32 5/16" (82 cm).
The labwasher can be built into a recess of 32 5/16" (82 cm) high by removing the lab washer top.
Leveling the legs
Any unevenness in the floor can be compensated for and the height of the machine raised or lowered by adjusting the four screw feet.
When the feet are screwed in, the machine can be moved back and forth on its rollers.
Removing the lid (if necessary)
^Open the door.
^Remove the fixing screws on both sides using a cross slotted screwdriver.
^Pull the machine lid approx. 5mm forwards, lift upwards and remove.
Protecting the countertop (depending on model)
Important for machines with steam condenser (depending on model):
To prevent steam damage to the
countertop, adhere the protective foil 9 13/16" x 22 13/16" (25 x 58 cm) underneath the countertop near the
steam condenser.
Depending on the requirements for installation, the following kit can be ordered from the Miele Technical Service Department.
Cover plate (protects the countertop)
The underside of the countertop is protected from steam damage by a stainless steel plate.
43
