Miller Electric A.B.B. Robot Interface Gas Control Hub And Spindle Operation, Safety Equipment

2-14. Installing Optional Reel-Type Wire

						1	Retaining Ring
						2	Lock
						3	Spanner Nut
1	2	3	4			4	Wire Retainer
						5	Welding Wire
						6	Wire Reel
			5			7	Hub
						Remove retaining ring. Pull lock
						and turn. Remove spanner nut, wire
				6		retainer, and wire reel from hub.
						To install wire lay wire reel on flat
						surface and install wire as shown.
Unlocked						Tighten spanner nut until lock is in
						position over hole in wire retainer.
						Pull lock and turn to insert locking
						pin into wire retainer.
					7	Slide wire reel assembly onto hub.
						Turn assembly until hub pin is
						seated in hole in reel. Reinstall
						retaining ring.

3

4

5

6

Wire Installation

ST-161 000-A / ST-152 463 / Ref. ST-157 999-A

SECTION 3 – OPERATION

3-1. Safety Equipment

			Wear the following while welding:
			1	Dry, Insulating Gloves
			2	Safety Glasses With Side
1	2	3		Shields
			3	Welding Helmet With Correct
				Shade Of Filter (See ANSI
				Z49.1)

sb3.1 1/94

OM-884 Page 17