4. Setup tab
3-12
Properties Settings Chapter 3
Functions of the Detail Of Output Setting dialog box
Allows you to make settings for the finishing functions, including stapling and
folding.
(1) Staple (when the Finisher or Booklet Finisher is installed)
Allows you to staple one set of printed documents at a time.
• Right Corner Printed documents are stapled in the upper right
corner.
• Upper 2-point Printed documents are stapled at two points along the
top edge.
• Left Corner Printed documents are stapled in the upper left corner.
• Left 2-point Printed documents are stapled at two points along the
left edge.
• Right 2-point Printed documents are stapled at two points along the
right edge.
☞ See p.1-4 for an illustration.
NOTES
• If a Staple setting has been made, printed pages are fed out into the Primary Tray.
• If the capacity of the Finisher or Booklet Finisher is exceeded, the stapling
operation may be canceled. Refer to the User Manual of the machine.
• If the original document for a print job consists of pages of different sizes,
stapling may be canceled.
• Take care when printing a document consisting of pages facing different
directions, since the stapling position will be determined by the direction of the
first page.
• Certain sizes or kinds of paper cannot be selected. For details, refer to the
User Manual of the machine.
C4027P211CA
(1) (3)
(2) (4)
(5)