This screen displays the software version of both the PLC and the PanelView. The Controller will stay on this screen for about 10 seconds or you can touch the picture of the blender to quickly skip to the Recipe Screen (Next Screen in sequence). The software versions are also available on the Panel View Configuration Screen.
Figure 27: Display Main (Recipe) Screen
|
|
|
|
|
|
| New Recipe |
|
| Recipe Entry Mode | |||||
|
|
|
| Input | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| Mixer Status |
|
|
|
| ||
|
|
|
|
|
|
| |
|
|
|
|
|
| ||
| Start/Stop |
|
|
|
| ||
| Blender |
|
|
|
| ||
|
|
|
|
|
| ||
|
|
|
| ||||
Immediately |
|
|
|
| |||
Stop Blender |
|
|
|
| |||
|
|
|
|
| |||
|
|
|
|
|
|
|
|
Accept New Recipe
Feeder Type
Indicator
Go To Inventory
Screen
Go To Recipe
Book
If not, the blender can be reconfigured for Quick Set, Percent, or Parts by entering the Setup menu and pressing the Recipe Format key. Then select the mode following the key prompt on the screen.
To access the Setup Menu to change the Recipe Mode and other controller features, refer to the following pages of this manual.
Controller Set-up
This section describes the proper setup of the Slide Gate blending system control parameters. These parameters are operator changeable; however, these items should only require setup during the initial installation. Only authorized personnel should change them. For security reasons, the menu that is used to access these parameters is password protected.
Many of the variables and setup parameters have been preset at the factory and do not need to be changed. However, this section of the manual will address all of the blender setup parameters that were available at the time of printing. The purpose of this is to familiarize the reader with all the setup parameters and their usage.
A complete listing of all default values is provided at the end of this manual.
Bulletin Number | Chapter 3: Installation | 37 of 102 |
