Mitsubishi Electronics CP900E JACK), Earth, BUSY1, Pin No, Ground, MEMORY, Function, Description, Plug pin No, MENU. See page, Circuit inside and pin No, in memory. See page 51, 52.)

EXTERNAL REMOTE TERMINAL 1

The image can be stored in memory by sending the remote signal through the external remote terminal on the rear panel. When the MEM&PRN(MEMORY & PRINT) function is set to ON, the image will be printed after being stored in memory.

•Make out the necessary circuit to use this function by referring to the following.

3

2

1

Circuit inside and pin No.

PRECAUTIONS

2EXTERNAL REMOTE TERMINAL SIGNAL ALLOCATION (STEREO

JACK)

2 3 1

Pin No.	Function	Description
1	Ground	Earth
2	MEMORY	Memory : When the signal becomes “LOW” from “HIGH”, the
		image is stored in memory. (When the signal has
		been “LOW” for 15ms or more, the image is stored
		in memory. See page 51, 52.)
3	BUSY1	Refer to the BUSY LEVEL setting of REMOTE SET in SERVICE
		MENU. See page 52.

To VCP

•When the signal from BUSY terminal is received with TTL level, keep the following.

IOL = 2mA or less, IOH = 1mA or less

IOL means the current flowing into the unit at Low output, IOH means the current flowing out of the unit at High output.

•Just after completing printing, there is a period that memory signal is not accepted.

From VCP

Plug pin No.

Circuit inside the VCP

DC5V

DTC124EK

10kΩ

22kΩ100Ω

22kΩ2MEMORY

	DC5V
	DMC2838
DTC124EK	10kΩ
22kΩ	100Ω
22kΩ	3 BUSY

FEATURES
CONNECTIONS
PREPARATION
PRINTING
ADJUSTMENTS
SHOOTING	TROUBLE-
	OTHERS

31