Mitsubishi Electronics CP900E unit, the unit, Refer to page, →Set KEY LOCK to “OFF”, Is the COMMENT set to “OFF”, →Set INPUT to “B&W”. Refer to page, The printing unit cannot be opened

ERROR MESSAGES & COUNTERMEASURES

Symptom

Check and Remedy

The stored image in the memory cannot be enlarged to fill the maxim print area.

Is the S size ink sheet installed when selecting “S” in MODE : AUTO/S? Oris the L size ink sheet installed when selecting “AUTO” in MODE : AUTO/S?→Check the current setting. Refer to pages 23-24.Is the paper size set to “N” in the size setting in LAYOUT menu?

→Set the size to “M” or “W”. Refer to pages 34, 41. Is the print area set correctly in LAYOUT menu?

→Check the setting of the print area. Refer to pages 40-42.

The colour or picture quality is different between the memorized image and the printed image.

When inputting monochrome image signal (without burst signal), sync. becomes unstable.

The colour or picture quality is different between the image on the monitor screen and the printed image. (When the colour and picture quality are same between the image stored in the memory and the printed image.)

The set comments do not appear on the print paper.

Is the colour of the image stored in the memory adjusted?

→Adjust the colour of the image stored in the memory with Colour adjustment display (COLOR ADJ). Refer to page 40.

Is INPUT in ANALOG COLOR ADJ set to “COLOR”?→Set INPUT to “B&W”. Refer to page 48.Is the image on the monitor screen adjusted?

→Adjust the image on the monitor screen with “MONI R-SUB” and “MONI B-SUB” in the OUTPUT menu.

Refer to page 50.

Is the COMMENT set to “OFF”?→Set COMMENT to “ON”. Refer to page 43. Is the comment inputted?→Input the comment on the menu. Refer to pages 43-44.

Wired remote control unit cannot be operated.	Is the plug of the remote control unit disconnected from its terminal on the
	unit?
	→ Connect the plug of the remote control unit to the REMOTE terminal on
	the unit.
	The supplied remote control unit can not be used by connecting to the

external remote terminal on the rear panel of this unit.Is the wired remote control unit for this unit (accessory) used?→Use the remote control unit for this unit.Is PAPER HOLD set to “ON”, and is printed paper kept at the print outlet?→Remove the printed paper from the print outlet. Is KEY LOCK set to “ON”?→Set KEY LOCK to “OFF”.

The printing unit cannot be opened.

Is the paper cut after prinitng with THERMAL : ON and AUTO CUT : OFF?→Press MEMORY button while pressing MONITOR button to cut the printed paper.