Mitsubishi Electronics CP900E OFF, NOR, ILL, INV, ALL, OFF, LOW, HIGH, “LOW”, NO DSR, “HIGH”, STROBE, STROBE, RESPONSE, MECHA ERR, MEDIA ERR, REMAINING, ERR RES OK, BUSY LEVEL

ADJUSTMENTS & SETTINGS (SERVICE MENU)

RS232C SET RS-232C signal setting display

•This menu does not work when selecting THERMAL : ON or MULTI : OFF(PRN SELECT).

BAUD RATE Set the baud rate of RS-232C.Set the baud according to the connecting device.COMMAND TYPE Sets the command type of RS-232C.Selects the command type of RS-232C to control this unit.

•Select “A” for normal setting. Depending on the connected equipment, select “B” or “C”.

RS232C SET
BAUD RATE	1200/2400/4800/9600
COMMAND TYPE	A/B/C
RESPONSE	OFF/ON
ERR RES OK	NOR/ILL/INV/ALL
NO DSR	OFF/ON

RESPONSE	Selects whether this unit sends RS-232C response to the host
	computer or not.
OFF	Does not send response.
ON	Sends normal response.
ERR RES OK	Selects the response code when an error occurs.
NOR	Sends the regular response.
ILL	Sends “job end” even if ILLEGAL error occurs.
INV	Sends “job end” even if INVALID error occurs.
ALL	Sends “job end” when any error occurs.
NO DSR	Sets to use 232C, DSR and DTR.
	Sets “NO DSR” according to the connecting device.
OFF	Uses NO DSR.
ON	Does not use NO DSR.

REMOTE SET Remote signal setting display

BUSY LEVEL	Selects the level of BUSY signal from the remote terminals 1 and 2
	on the rear panel.
LOW	The VCP cannot accept the remote input signal when the signal is
	“LOW”.
HIGH	The VCP cannot accept the remote input signal when the signal is
	“HIGH”.

•The default setting is “HIGH”.

BUSY 1,2 SELECT Selects when the BUSY signal is outputted from the remote terminals 1 and 2 on the rear panel.

PRINTING Outputs BUSY signal during printing.

MECHA ERR Outputs BUSY signal when a mechanical error occurs in this unit or IC chip is not installed. BUSY signal is also outputted when the printing mechanism is pulled out or the menu is displayed on the monitor.

MEDIA ERR Outputs BUSY signal when an error for paper or ink sheet occurs. MEMORY STOP Outputs BUSY signal when MEMORY button is not functioning.

STROBE 1V After outputting BUSY signal, memory is taken in by waiting to 1 vertical period.

STROBE 2V After outputting BUSY signal, memory is taken in by waiting to 2 vertical periods.

REMAINING Outputs BUSY signal while the remains of ink sheet becomes the value set in REMAINING Q’ty.

•When either STROBE 1V or STROBE 2V is set to OFF, the other is available for setting.

REMOTE SET
BUSY LEVEL	LOW/HIGH
BUSY1,2 SELECT
PRINTING	OFF/1/2/1&2
MECHA ERR	OFF/1/2/1&2
MEDIA ERR	OFF/1/2/1&2
MEMORY STOP	OFF/1/2/1&2
STROBE 1V	OFF/1/2/1&2
STROBE 2V	OFF/1/2/1&2
REMAINING	OFF/1/2/1&2

52