69
ENGLISH
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••Operations
•Using the web function of this unit is required to input
“E-Mail Address” and “Recorder ID.”
step5. Check the contents to be transmitted to the PC.
Remain: Transmits signal when the remaining
capacity reaches the value set for Call out setting.
Temp/Fan: Transmits signal when the high
temperature is detected or the fan is stopped.
Reboot: Transmits signal when the unit is rebooted.
Record: Transmits signal when the recording is
started.
Alarm: Transmits signal when the alarm recording
is started.
Sensor: Transmits signal when the signal is input
to the terminal on the rear panel.
•Using the web function of this unit is required to
change the contents to be transmitted.
step5. Check the settings of “IP Address” and “Target Port.”
•This item is used to transmit warning signals or
signals of status change such as a short-circuit
of a rear terminal to the PC connected.
•When selecting “Test,” the sending test for the
set IP address and port is executed.
•Using the specified application is required to change
the IP address and target port. Consult your dealer
about the specified application.
•Transmission of signal to broadcast address is not
supported.
step6. Check the contents to be transmitted to the PC.
Remain: Transmits signal when the remaining
capacity reaches the value set for Call out setting.
Temp/Fan: Transmits signal when the high
temperature is detected or the fan is stopped.
Reboot: Transmits signal when the unit is rebooted.
Record: Transmits signal when the recording is
started.
Alarm: Transmits signal when the alarm recording
is started.
Sensor: Transmits signal when the signal is input
to the terminal on the rear panel.
•Using the specified application is required to change
the contents to be transmitted. Consult your dealer
about the specified application.
step7. Select “Return” in the screen of <LAN B
(Communication) Setting>.
•When the setting of “IP Address,” “Sub Net Mask,”
“Gateway,” or “Service Port Setting” is changed,
the power turns off automatically and then the
unit restarts.
LAN A (NAS) Setting
This item is used to make the communication settings
between this unit and the copy devices.
•Consult your dealer about the NAS devices supported.
System Menu
COM/LAN1
NAS Device 1 to 8 Information
1 to 8
LAN A (NAS) Setting
Device Information
2
LAN A Address Setting
1
4
step
2
step
1
step
3
step1. Set the IP address, sub net mask, and Gateway.
•MAC address is shown on the bottom of the
screen of <LAN A (NAS) Setting>.
•Do not assign the same IP address or Network
Address for LAN A and LAN B.
•Do not assign “000.000.000.000” to IP address and
broadcast address. If this address is assigned,
communications or any other functions of this unit may
not be performed correctly.
•The setting cannot be changed during recording. Stop
recording before changing the setting.
step2. Check the IP address, directory, NAS user ID, and
NAS password.
• After checking, you can test the actual connecting
status by executing the mount test. Select “Test”
to execute the mount test.
•Using the web function of this unit is required to
input the IP address, directory, NAS user ID, and
NAS password.
step3. Select “Return” in the screen of <LAN A (NAS)
Setting>.
•When the setting is changed, the power turns off
automatically and then the unit restarts.