Mitsubishi Electronics MDT651S manual Installing the monitor, Using the monitor without the bezel

P-2	Installing the monitor
		Carry out as necessary

Using the wall mount or ceiling mount

Lay the screen face down

Lay the protective sheet on a table, which was wrapped around the monitor when it was packaged, beneath the screen surface so as not to scratch the screen surface.

Failure to follow the correct mounting procedures can result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation.

Failure to follow these recommendations can void your warranty.

Use M8 screws (having a length 15 mm longer than the thickness of the mounting bracket) and tighten them securely. Prevent the screws from loosening using spring washers, etc. MITSUBISHI ELECTRIC recommends using mounting interface that comply with TÜV-GS and/or UL1678 standard in North America.

749	749	Handles
200	200
		200	436.5
		200	436.5
Table	Protective Sheet	(mm)

CAUTION:

For preventing the monitor from falling.

•Install the monitor with metal brackets for wall or ceiling installation (commercially available) on your own responsibility. For detailed procedures of installation, refer to the instructions of the metal brackets.

•To lessen the probability of injury and damage resulting from fall of the monitor in case of earthquake or other disaster, be sure to consult the bracket manufacturer for installation location.

•To lessen the risk of falling of the monitor, thread commercially available rope through the handles at the right and left of the monitor and secure the rope to the wall mount brackets or ceiling mount brackets.

•Do not sleep where the monitor may topple over or fall in case of an earthquake or other disaster.

•Use screws having enough strength to support the LCD display monitor (made of stainless steel etc.).

Using the monitor without the bezel

CAUTION:

•MDT651S satisfies the UL requirements as long as it is used with the bezel attached. When using the monitor without the bezel, in which case the monitor doesn’t satisfy the UL requirements, cover the UL certification marking on the rear panel with the supplied label.

•To prevent static damage to circuit boards, attach the protective cover to the LCD panel.

1.Unscrew the screws that hold the bezel to remove the bezel from the monitor.

(a)(a)

(a)

(a): Screws for bezel

2.Place the supplied protective cover (b) on the LCD panel using double-sided adhesive tape.

CAUTION:

Never touch the circuit boards because they may be damaged.

(b)

3.Cover the UL certification marking on the rear panel with the supplied label (c).

(c)

English

Downloaded From TV-Manual.com Manuals English-15