Mitsubishi Electronics MDT651S manual Advanced Option

OSD screen functions (continued)

ADVANCED OPTION

English

￿INPUT RESOLUTION

* For the RGB3 and RGB4 inputs only.

You can select the following resolutions according to the input signal: AUTO, 1024x768, 1280x768, 1360x768, 1366x768, 1400x1050, 1680x1050, 1600x1200, and 1920x1200. AUTO selects the resolution automatically. The setting you select becomes effective when POWER is turned OFF and ON again.

￿BLACK LEVEL EXPANSION

Selects a level of black expansion from “OFF”, “MIDDLE” and “HIGH.”

In case of go under the black cut-off level, please adjust the “Black level” in moderation on OSD menu.

￿INPUT CHANGE

You can select the time for input switching from QUICK and

NORMAL.

NOTE: When you select QUICK, slight noise may appear.

￿SCAN MODE

*For the RGB1 (HDMI), DVD/HD, VIDEO<S>, and VIDEO inputs only.

You can select the image display area.

OVERSCAN: About 95% of the input image is displayed.

UNDERSCAN: Almost 100% of the input image is displayed.

￿SCAN CONVERSION

*For the RGB1 (HDMI), DVD/HD, VIDEO<S>, and VIDEO inputs only.

You can select the IP conversion mode. PROGRESSIVE: Interlace signals are converted into

progressive signals. Select this setting for normal cases.

INTERLACE: Interlace signals are displayed without being converted. Though this setting is suitable for motion images, still images aren’t displayed properly.

￿FILM MODE

You can select the film mode function.

AUTO: Images of 24 frames per second are detected, subjected to interpolation, and then displayed.

OFF: The input video signals are displayed without being subjected to any processing.

NOTE: When FILM MODE is AUTO, set SCAN CONVERSION to PROGRESSIVE. See page 49.

￿

￿

IR CONTROL

You can lock the wireless remote control.

Select from the following two modes using the and buttons and then determine the selected mode by pressing the SET button.

NORMAL:	All the remote control operations are
	enabled.
PRIMARY:	The first MDT651S monitor of those multi-
	connected via RS-232C is designated as

PRIMARY.

SECONDARY: MDT651S monitors other than the first

	one multi-connected via RS-232C are
	designated as SECONDARY.
LOCK:	All the remote control operations are
	disabled.

NOTE: When you hold down the DISPLAY button on the wireless remote control for at least 5 seconds, the NORMAL mode is activated.

You can lock the wireless remote control independently from the control buttons on the rear of the monitor. See page 51.

TILING

You can enlarge an image across multiple screens. A single large screen can be configured with up to 25 monitors. You can also divide the displayed image into up to 5 pieces horizontally and vertically.

NOTE: It is required to connect the same video signal to each monitor via a distributor or RGB OUT.

When TILING is activated, PIP, POP, SBS, and STILL are disabled.

TILING doesn’t work in the REAL picture size mode.

H MONITORS:	Select the number of images obtained by
	horizontal division.
V MONITORS:	Select the number of images obtained by
	vertical division.
POSITION:	Select the area you want to enlarge.

FRAME COMP.: When displaying an image across multiple

	monitors, you can select the mode to
	compensate for the bezel widths for
	smooth and natural display.
ENABLE:	When you select ON, the image in the
	selected area is enlarged on the screen.

Downloaded From TV-Manual.com Manuals English-49