OPERATING PROCEDURE | PHOTOS |
3. Removing the electrical box | Photo 5 |
|
(1)Remove the panel (Refer to 1.) and the corner box.
(2)Remove the indoor/outdoor connecting wire, the sensor holder, the electrical cover and the earth wire. (Refer to 2.)
(3)Disconnect the following connectors on the electronic con- trol P.C. board;
fan motor <CN211>, indoor coil thermistor <CN112>, vane motor <CN151>, interlock switch <CN1R1>, plasma power
P.C. board <CN1T1>.
(4) Unhook the catches of the electrical box, and pull out the electrical box. (See Photo 3)
Be sure to assemble the
4. Removing the nozzle assembly | Photo 6 | ||
(1) | Remove the panel (Refer to 1.) and the corner box. |
|
|
(2) | Remove the V.A. clamp, and then the indoor/outdoor con- |
| Interlock switch |
| necting wire. (See Photo 2) |
|
|
(3)Remove the sensor holder and the electrical cover. (See Photo 3.)
(4)Disconnect the following connectors on the electronic con- trol P.C. board;
vane motor <CN151>, interlock switch<CN1R1>.
(5) | Remove the power monitor receiver P.C. board holder and |
|
| the plasma power holder P.C. board holder. (See Photo 4) |
|
(6) | Pull out the drain hose from the nozzle assembly and |
|
| remove the nozzle assembly. |
|
(7) | Remove the interlock switch. | Screws of the interlock switch |
5. Removing the vertical vane motor unit | Photo 7 | ||
(1) | Remove the nozzle assembly. (Refer to 4.) |
|
|
(2) | Remove the crank of the vertical vane motor unit from the |
| Screws of the vertical vane motor unit cover |
|
| ||
| arm of the vertical vane. |
|
|
(3) | Remove the screw of the vertical vane motor unit, and pull |
|
|
| the vertical vane motor unit. |
|
|
(4)Remove the screws of the vertical vane motor unit cover.
(5)Remove the crank of the vertical vane motor unit from the shaft of the vane motor.
(w) Only the crank of the left side vertical vane motor unit. |
|
|
(See Photo 7) |
|
|
(6) Remove the vertical vane motor from the the vertical vane | Crank of the vertical | Screw of the vertical |
motor unit. | vane motor unit | vane motor unit |
(7)Disconnect the connector of vertical vane motor from the vertical vane motor.
Photo 8
Screws of the vertical vane motor unit cover
Crank of the vertical | Screw of the vertical | |
vane motor unit | ||
vane motor unit | ||
|
38
