| OPERATING PROCEDURE |
| PHOTOS | |
6. Removing the horizontal vane motor | Photo 9 |
|
| |
Screws of the horizontal |
| |||
(1) | Remove the nozzle assembly.(Refer to 4.) |
| ||
| vane motor unit cover |
| ||
(2) | Remove the screws of the horizontal vane motor unit, and |
|
| |
|
|
| ||
|
|
| ||
| pull out the horizontal vane motor unit. |
|
|
|
(4)Remove the screws of the horizontal vane motor unit cover.
(5)Remove the horizontal vane motor from the horizontal vane motor unit.
(3) Disconnect the connector from the horizontal vane motor.
Screws of the horizontal vane motor unit
7. Removing the indoor fan motor and the line flow fan Photo 10
(1)Remove the panel (Refer to 1.) and the corner box.
(2)Remove the sensor holder, the power monitor receiver P.C.
| board holder, the electrical box (Refer to 3.) and the nozzle |
|
| Motor band | |
| assembly (Refer to 4.). | |
|
| |
|
| |
(4) | Remove the screws fixing the motor bed. (See Photo 10) |
|
(5) | Loosen the screw fixing the line flow fan. (See Photo 11) |
|
(6) | Remove the motor bed together with fan motor and motor |
|
|
| band. |
|
|
(7) | Release the hooks of the motor band. Remove the motor |
|
|
| Screws of | ||
| band. Pull out the indoor fan motor. |
| |
|
| the motor bed | |
(8) | Remove the indoor coil thermistor from the heat exchang- |
| |
| er. |
|
|
(w) Install the indoor coil thermistor (RT12) in its former posi- |
|
| |
| tion when assembling it. (Refer to Photo 13) |
|
|
(9) | Remove the screws fixing the left side of the heat |
|
|
| exchanger. (See Photo 12) | Photo 11 | |
(10)Lift the heat exchanger, and pull out the line flow fan to the
Photo 13
Screw of
the line flow fan
Photo 12
Indoor coil thermistor (RT12)
Screws of the left side of the 
heat exchanger
39
