11 
DISASSEMBLY INSTRUCTIONS
<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not. | (2) The terminal with this connector has the |
| locking mechanism. |
Sleeve
Locking lever
MSZ-FD25VA MSZ-FD25VAS
1Slide the sleeve. | 1Hold the sleeve, and |
2Pull the terminal while | pull out the terminal |
pushing the locking | slowly. |
lever. | Connector |
| |
| NOTE : |
| Turn OFF power supply |
before disassembling. |
| OPERATING PROCEDURE |
| PHOTOS | |||
1. Removing the panel | Photo 1 |
|
| |||
(1) | Press and unlock the knobs on both sides of the front |
|
| |||
|
|
|
|
| ||
| panel and lift the front panel until it is level. Pull the hinges |
|
|
|
|
|
| forward to remove the front panel. |
|
|
|
|
|
(2) | Remove the horizontal vanes. |
| Horizontal vane |
|
|
|
Front panel | ||||||
(3)Remove the screw caps of the panel. Remove the screws. (See Photo 1)
(4) Hold the lower part of both ends of the panel and pull it slightly toward you, and then remove the panel by pushing it upward.
Screws of the panel
36
