Mitsubishi Electronics WD-65C8 manual Programming the Remote Control, Dvd, CABLE/SAT VCR DVD Audio

68Appendices

Appendix C: Programming the Remote Control, continued

Programming the Remote Control

1.Move the slide switch at the top of the remote to the position for the product you want to control. Refer to the table below. Only one of each device type can be controlled in each slide-switch position.

Switch Position	Affected Device
Cable/SAT	Cable Box
	DTV Receiver
	Satellite Receiver
VCR	VCR
	DVR
	Laser Disc Player
	DVD Player/Recorder
DVD	DVD Player/Recorder
	DVR
	Laser Disc Player
	VCR
Audio	A/V Receiver
	Audio Amplifier
	CD Player

2.Press and hold POWER on the remote control for several seconds until the button blinks twice and goes off.

6.Once you have found the correct code, write it in the space below for future reference.

Switch Position	Device Type	Code
CABLE/SAT
VCR
DVD
AUDIO

Code Verification

To determine the code programmed for any position of the slide switch:

1.Move the slide switch to the position you wish to verify.

2.Press and hold POWER on the remote control for several seconds until the button blinks twice and goes off.

3.Press keys 9 9 0

4.Press 1 and count the blinks of the power button. Write down the number of blinks as the first digit of the code.

5.Repeat step 4 for the second, third, fourth, and fifth digits of the code.

3.Release the POWER button.

4.Enter the first five-digit code listed for your equip- ment.

•The POWER button blinks twice when you start to enter the code and then once for each addi- tional keypress.

•The POWER button blinks twice when you finish entering a valid code.

•Move the slide switch to another position if you need to start over or wish to exit programming mode.

5.Point the remote control at the equipment and press POWER. If the product has no power on/off

function, press a different key, such as (Play),

(Stop), VOL , or MUTE.

•If the equipment responds, the remote control is properly programmed to operate the equip- ment.

•If the equipment does not respond, repeat steps 2–4 with the next five-digit code listed for your equipment.

Audio Lock: Universal A/V Receiver Control

With Audio Lock active, the remote control operates the volume and mute functions of the A/V receiver in all positions of the slide switch. Activate Audio Lock if you normally use an A/V receiver with your TV and other A/V equipment.

1.Program the AUDIO position for your A/V receiver as described earlier in this section.

2.With the slide switch in the AUDIO position, press and hold POWER on the remote control for several seconds until the button blinks twice and goes off.

3.Press keys 9 9 3 ENTER

The POWER button will blink twice to indicate Audio Lock is active.

To Reset the Remote Control to Operate Volume and Mute for the TV Speakers

1.Press and hold POWER for several seconds until the key blinks twice and goes off.

IMPORTANT

You may need to reprogram the remote control after changing the batteries.

2.2. Press keys 9 9 3 VOL .

The POWER key will blink four times to indicate Audio Lock has cleared.