Mitsubishi Electronics WD-65C8 Front-Panel Indicators, POWER/TIMER Indicator, Status Indicator

81. Television Overview

Front-Panel Indicators

Off	Steady On		Slow Blinking	Fast Blinking
POWER/TIMER Indicator
LED Color	TV Condition			Additional Information
None	TV is powered off.			Normal operation.
Green	TV is powered on.			Normal operation.
Green	TV powered off, auto-on timer is set.			Normal operation. TV can be turned on at any time.
Green	• TV just plugged into AC outlet.			Wait approximately two minutes for blinking to stop before
				turning on. Normal operation.
	• AC just restored after power failure.
	• TV is rebooting after System
		Reset used.
	• TV is rebooting after power
		fluctuation or receiving abnor-
		mal digital signals from a digital
		channel or digital device.
	• You have begun the procedure
		to update software from an
		authorized flash memory device.
STATUS Indicator
LED Color	TV Condition			Additional Information
None	Normal TV on or standby condition.			Normal operation.
Yellow	TV is too hot.			The TV will display a warning message and shut off if it overheats.
				• Ambient room temperature may be too high. Turn off the TV
				and let the room temperature to drop.
				• Clear blocked air vents. Ensure at least a four-inch clear-
				ance on all sides of the TV.
				• Clean the lamp-cartridge air filter. See Appendix D.
Red	TV may require service.			Turn off the TV and unplug the set from the AC power source.
				Wait one minute and then plug the set back in. See Appendix F.
				If the LED is still on, contact your dealer or a Mitsubishi Autho-
				rized Service Center. Go to www.mitsubishi-tv.com or call
				1-800-332-2119 to receive Authorized Service Center information.
LAMP Indicator
LED Color	TV Condition			Additional Information
None	Normal TV on or standby condition. Normal operation.
Green	TV just powered off and lamp is			Starts to blink 60 seconds after turning off TV. TV can be turned
	cooling.			back on before blinking starts or after blinking stops, but not
				while the indicator is blinking. Normal operation.
Yellow	1. Lamp access door is open or			TV will not operate until lamp access door is secure. See
		not secure.		Appendix D for installation information.

2. No lamp installed.	TV will not operate without a lamp. See Appendix D for installa-
	tion information.

Red	Lamp no longer illuminates and has
	reached the end of the lamp life.

Replace the lamp. The TV will not operate when the lamp no longer illuminates. See Appendix D for installation information.