Replacing the lamp (continued)
To replace the lamp:
1.Unplug the power cord from the outlet or appliance inlet.
2.Loosen two screws (a) that are securing the lamp cover using a Phillips screwdriver and remove the lamp cover (b) from the projector.
(b)
(a)
3.Loosen two screws (c) that are securing the lamp box to be removed using a Phillips screwdriver.
(c)
4.Pull out the lamp box by the handle while holding the projector.
t 1VMMUIFMBNQCPYPVUPGUIFQSPKFDUPSTMPXMZ
When the lamp is broken, glass fragments may be scattering by quickly pulling out the lamp box.
t %POPUTQJMMMJRVJEPOUIFSFNPWFEMBNQCPYPS do not place it near any flammable object or where children can reach to prevent injury or fire.
5.Load a new lamp box securely into the projector in the right orientation.
6.Tighten two screws (c) of the new lamp box tightly using a Phillips screwdriver.
(c)
t .BLFTVSFUIBUUIFTDSFXTBSFUJHIUFOFEmSNMZ
7.Insert the lamp cover (b) into the projector and tighten two screws (a) on the lamp cover firmly using a Phillips screwdriver.
(b)
(a)
t :PVDBOOPUUVSOPOUIFQSPKFDUPSXJUIPVU attaching the lamp cover.
Reset of the lamp operation time
Plug in the power cord and reset the lamp operation time by holding down the , , and POWER buttons on the control panel at the same time about 3 seconds.
Important:
t Unless these 3 buttons are pressed at the same time, the lamp operation time isn’t reset.
t Make sure that the STATUS indicator blinks twice and the lamp operation time is reset successfully.
t The projector doesn’t turn on if the lamp cover isn’t attached securely.
t Be sure to reset the lamp operation time whenever you replace the lamp.
t Do not reset the lamp operation time unless you replace the lamp.
t The lamp is fragile. If it is broken, be careful not to cut yourself with glass fragments.
Caution:
tThis projector uses a lamp that contains mercury. Disposal of the lamp or the projector with the lamp may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org. (For the U.S. only.)
