703The printer sensed a calibration of
704Printer didn’t detect a sense mark within the maximum feed length or is out of supplies. Check or load supplies.
705Invalid batch received.
750Printhead is overheated, turn off the printer to let it cool.
751Printer didn’t detect a sense mark when expected.
752Printer detected a sense mark in the wrong place.
753Printer detected a sense mark that is too long.
754Out of ribbon or ribbon jam. Check or load ribbon. Remove any slack in the ribbon by turning the
755Printhead is open. Close the printhead.
756Out of supplies. Load supplies.
757Reload supplies (supply length mismatch).
758The supply was not seen or the
759Knife is not moving. Call Technical Support.
760Knife jam. Remove any jammed tags from the knife. Call Technical Support.
761Stacker is full or jammed. Empty the stacker or clear the jam before continuing. The printer does not recalibrate after this error.
Troubleshooting
