12 Getting Started (cont.)
Alert Tone Indications
The MTS 2000 radio generates a number of audible tones to indicate radio operating conditions:
•Low Battery – A low-battery condition is indicated by a high-pitched, cricket-like “chirp-chirp” when the PTT switch is released following a transmission.
•Successful Power-Up – A short, medium-pitched tone when the radio is first turned on indicates that the radio has passed its power-up self test and is ready for use.
•Unsuccessful Power-Up – A short, low-pitched tone when the radio is first turned on indicates that the radio has failed its power-up self test and is not ready for use. Contact your service representative for service.
•Transmit on Receive-Only Mode – If you press the PTT switch while tuned to a “receive-only” mode, you will hear a continuous, low-pitched alert tone, indicating that no transmission is possible on this mode. This tone will continue until the PTT switch is released.
•Transmit Inhibit on Busy Mode – If you press the PTT switch while the mode is busy, you will hear a continuous, low-pitched alert tone, indicating that no transmission is possible on this mode. This tone will continue until the PTT switch is released.
•Invalid Mode – A continuous, low-pitched tone is heard when an invalid or unprogrammed operation is attempted on the radio.
•Valid (Good) Key Press – A short, medium-pitched tone when a keypad key is pressed indicates that the key press was accepted.
•Invalid (Bad) Key Press – A short, low-pitched tone when a keypad key is pressed indicates that the key press was rejected.
•Emergency Alarm Entry – A short, medium-pitched tone when the emergency button is pressed indicates that the radio has entered the emergency mode.
•Emergency Alarm/Call Exit – A continuous, medium-pitched tone when the radio is in the emergency mode indicates that the radio has exited the emergency mode.
•Failsoft (Trunked Systems Only) – A faint “beeping” tone every ten seconds indicates that the radio is operating in the failsoft mode.
•Time-Out Timer Warning – Your radio’s time-out timer limits the length of your transmission time. When you are pressing the PTT switch (transmitting), a short, low-pitched warning tone will sound four seconds before the allotted time will expire.
•Time-Out Timer Timed-Out – If you hold down the PTT switch longer than the time-out timer’s allotted time, a continuous, low-pitched tone will sound, indicating that your transmission has been cut off. This tone will continue until the PTT switch is released.
•Phone Busy – A “bah-bah-bah-bah” tone when telephone interconnect is accessed indicates that all available modes are busy and the radio is in queue for the next available phone line.
