A
Configure and Environment Commands
The parameters to be configured are listed in the following table:
Table A-1. ENV Command Parameters
ENV Parameter and Options | Default | Meaning of Default | |
|
|
|
|
|
|
| |
Bug or System environment [B/S] | B | Bug mode |
|
|
|
| |
Field Service Menu Enable [Y/N] | N | Do not display field service | |
|
| menu. | |
|
|
| |
Remote Start Method Switch [G/M/B/N] | B | Use both the Global Control and | |
|
| Status Register (GCSR) in the | |
|
| VMEchip2, and the | |
|
| Multiprocessor Control Register | |
|
| (MPCR) in shared RAM, | |
|
| methods to pass and start | |
|
| execution of | |
|
| program. | |
|
|
| |
Probe System for Supported I/O Controllers [Y/N] | Y | Accesses will be made to the | |
|
| appropriate system busses (e.g., | |
|
| VMEbus, local bus) to determine | |
|
| presence of supported | |
|
| controllers. | |
|
|
| |
Negate VMEbus SYSFAIL* Always [Y/N] | N | Negate VMEbus SYSFAIL after | |
|
| successful completion or | |
|
| entrance into the bug command | |
|
| monitor. | |
|
|
| |
Local SCSI Bus Reset on Debugger Startup [Y/N] | N | Local SCSI bus is not reset on | |
|
| debugger startup. | |
|
|
| |
Local SCSI Bus Negotiations Type [A/S/N] | A | Asynchronous | |
|
|
| |
Industry Pack Reset on Debugger Startup [Y/N] | N | Industry Pack(s) is/are not reset | |
|
| on debugger startup. | |
|
|
| |
Ignore CFGA Block on a Hard Disk Boot [Y/N] | Y | Enable the ignorance of the | |
|
| Configuration Area (CFGA) | |
|
| Block (hard disk only). | |
|
|
| |
Auto Boot Enable [Y/N] | N | Auto Boot function is disabled. | |
|
|
| |
Auto Boot at | Y | Auto Boot is attempted at power | |
|
| up reset only. | |
|
|
| |
Auto Boot Controller LUN | 00 | LUN of a disk/tape controller | |
|
| module currently supported by | |
|
| the Bug. Default is $0. | |
|
|
| |
Auto Boot Device LUN | 00 | LUN of a disk/tape device | |
|
| currently supported by the Bug. | |
|
| Default is $0. | |
|
|
|
|
MVME162 Embedded Controller Installation Guide |