Entering Debugger Command Lines
Expression as a Parameter
An expression can be one or more numeric values separated by the arithmetic operators: plus (+), minus
Numeric values may be expressed in either hexadecimal, decimal, octal, or binary by immediately preceding them with the proper base identifier.
Data Type | Base | Identifier | Examples | |
|
|
|
| |
|
|
|
|
|
Integer | Hexadecimal | $ | $FFFFFFFF | |
|
|
|
|
|
Integer | Decimal | & | &1974, |
|
|
|
|
|
|
Integer | Octal | @ | @456 |
|
|
|
|
|
|
Integer | Binary | % | %1000110 |
|
|
|
|
|
|
If no base identifier is specified, then the numeric value is assumed to be hexadecimal.
A numeric value may also be expressed as a string literal of up to four characters. The string literal must begin and end with the single quote mark (’). The numeric value is interpreted as the concatenation of the ASCII values of the characters. This value is
String | Numeric Value |
Literal | (In Hexadecimal) |
|
|
|
|
’A’ | 41 |
|
|
’ABC’ | 414243 |
|
|
’TEST’ | 54455354 |
|
|
Evaluation of an expression is always from left to right unless parentheses are used to group part of the expression. There is no operator precedence. Subexpressions within parentheses are evaluated first. Nested parenthetical subexpressions are evaluated from the inside out.
4 |
MVME162IG/D2 |
