(p) Adjust the REFERENCE Modulation value by using the DOWN arrow key. Repeat the
step above until DEV 2 = DEV 1.
3. Battery Save Enable
Battery Save Enable allows you to enable the Battery Save Squelch option in ALIGN RADIO
for a particular channel. The battery save will be turned off while scan is activated, and when
scan is deactivated this function becomes enabled on that channel and resume its
programmed state. When aligning Battery Save Enable, you can notice the change during
the alignment process or in "real time." You do not have to reprogram the radio to see the
immediate change. In order to enable this parameter, follow the steps below:
(a) Follow the Setup Procedure in Section VI-A, Fig. 8.
(b) Use the UP/DOWN arrow keys to toggle this option.
(c) Invoke a new channel to check this change, or key up and de-key the radio.
D. Align Scan Controls
If you had selected the ALIGN SCAN CONTROLS function in the SERVICE screen, the
system will display the screen shown in Figure 12. These screens will allow you to align
Scan monitor hold time, Scan receive response time, Scan transmit response time, and Scan
priority squelch. Each of these parameters are explained below, followed by the procedure
needed to set these parameters correctly for the radio being aligned. Note that on certain
alignment procedures, the last step states "Reprogram radio," this means AFTER all
aligning is completely finished you must reprogram the radio. You do not have to reprogram
the radio after each parameter is aligned.

Figure 12. Align Scan Menu

MOTOROLA Radio Service Software
SABER Model
Ver. R05.00.00
Use UP / DWN Arrows to Change Value.
PGUP /PGDN to Change Rapidly.
Monitor Hold Time
Receive Response Time
Transmit Response Time
Priority Squelch
F1
HELP
F2
F3
F4
F5
PRINT
SCREEN
F6
F7
F8
F9
F10
EXIT
ALIGN SCAN PARAMETERS
03
03
03
08
0
10
20
30
40
50
60
70
80
90
100%
R07.01.00
Servicing the Radio 33