Motorola VT2442 LAN Configuration fields and buttons continued, Field or Button, Description

Overview Installation Troubleshooting Contact FAQ Glossary License

			Configuration:	Basic	Advanced TCP/IP Wireless
LAN Configuration fields and buttons (continued)
Field or Button		Description
Enable DHCP		If selected, the DHCP server on the voice gateway assigns IP addresses to the computers and
Server		other hosts on your network, if they have DHCP enabled (see “Configuring TCP/IP” on
		page 53). By default, the voice gateway DHCP server is enabled.
		If there is another DHCP server running on your network (on another router), you must disable
		one of the DHCP servers.
	Start IP	Sets the first IP address assigned by the DHCP server, in dotted-decimal format. It must be
		greater than the IP address value of the voice gateway. For example, if the IP address of the
		voice gateway is 192.168.15.1 (default), the starting IP address must be 192.168.15.2 (or
		higher).
	End IP	Sets the final IP address assigned by the DHCP server, in dotted-decimal format. It cannot
		exceed the subnet limit of 254. For example, the default is 192.168.15.254. If the DHCP server
		runs out of DHCP addresses, users cannot access network resources. If this happens, increase
		the End IP (to the limit of 254) or reduce the Lease Time.
		If you change Start IP or End IP, be sure they are in the range for specified by the Subnet IP
		Address and Netmask. For example, if the voice gateway IP address is 192.168.15.1 (the
		default) and you set Start IP and End IP to 192.168.0.2 and 192.168.0.100, respectively,
		computers with DHCP enabled cannot communicate with the voice gateway.
	Lease Time	Sets the time, in seconds, that a network computer remains connected to the voice gateway
		using its current assigned IP address. At the end of this time, the DHCP server renews the lease
		or assigns the computer a new IP address. The default is 3600 seconds (1 hour). The maximum
		is 999999 seconds (about 278 hours).

Enable DHCP Relay If selected, the voice gateway forwards requests and responses between the computers on your network (the DHCP clients) and the DHCP server you chose to use for your network.

Relay IP	If you select Enable DHCP Relay, type the IP address of the DHCP server in dotted-decimal
	format.
Server and Relay	If selected, you must carefully configure the IP address, Subnet Mask, and DNS settings of
Off	every host on your network. Do not assign the same IP address to more than one host. Your
	voice gateway must be on the same subnet as the other hosts.

VT2442 Voice Gateway User Guide 21