Motorola VT2442 manual Comply with all instructions that accompany this equipment

Overview Installation Troubleshooting Contact FAQ Glossary License

Configuration: Basic Advanced TCP/IP Wireless

IMPORTANT SAFETY INSTRUCTIONS — When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

•Read all of the instructions listed here and/or in the user manual before you operate this equipment. Give particular attention to all safety precautions. Retain the instructions for future reference.

•This device must be installed and used in strict accordance with manufacturer’s instructions as described in the user documentation that comes with the product.

•Comply with all warning and caution statements in the instructions. Observe all warning and caution symbols that are affixed to this equipment.

•

•

Comply with all instructions that accompany this equipment.

Do not overload outlets or extension cords, as this can result in a risk of fire or electric shock. Overloaded AC outlets, extension cords, frayed power cords, damaged or cracked wire insulation, and broken plugs are dangerous. They may result in a shock or fire hazard.

•Route power supply cords so that they are not likely to be walked on or pinched by items placed upon or against them. Pay particular attention to cords where they are attached to plugs and convenience receptacles, and examine the point where they exit from the product.

•Place this equipment in a location that is close enough to an electrical outlet to accommodate the length of the power cord.

•

•

Place unit to allow for easy access when disconnecting the power cord of the device from the AC wall outlet.

Do not connect the plug into an extension cord, receptacle, other outlet unless the plug can be fully inserted with no part of the blades exposed.

•

•

Place this equipment on a stable surface.

It is recommended that the customer install an AC surge protector in the AC outlet to which this device is connected. This is to avoid damaging the equipment by local lightning strikes and other electrical surges.

•Do not cover the device, or block the airflow to the device with any other objects. Keep the device away from excessive heat and humidity and keep the device free from vibration and dust.

•Wipe the unit with a clean, dry cloth. Never use cleaning fluid or similar chemicals. Do not spray cleaners directly on the unit or use forced air to remove dust.

•Operate this product only from the type of power source indicated on the product’s marking label. If you are not sure of the type of power supplied to your home, consult your dealer or local power company.

•Do not use this product near water for example, near a bathtub, washbowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool.

•Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.

•

•

Do not use the telephone to report a gas leak in the vicinity of the leak.

Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire. They may explode. Check with local codes for possible special disposal instructions.

•CAUTION: To reduce the risk of fire, use only No. 26 AWG or larger (e.g., 24 AWG) UL Listed or CSA Certified Telecommunication Line Cord.

•

•

•

•

Disconnect TNV circuit connector(s) before disconnecting power.

Disconnect TNV circuit connector before removing cover.

Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in safe operating condition.

SAVE THESE INSTRUCTIONS

VT2442 Voice Gateway User Guide iii