Moxa Technologies NPort 5600 user manual Serial Parameters

NPort 5600 Series User’s Manual Configuring NPort Administrator

Serial Parameters

ATTENTION

Check the serial communication parameters in your Serial Device’s user’s manual. You should set up NPort’s serial parameters with the same communication parameters used by your serial devices.

Baudrate

Setting	Factory Default	Necessity
50 bps to921.6 Kbps	115.2 Kbps	Required
Data bits
Setting	Factory Default	Necessity
5, 6, 7, 8	8	Required

When the user sets Data bits to 5 bits, the stop bits setting will automatically change to 1.5 bits.

Stop bits

Setting	Factory Default	Necessity
1, 1.5, 2	1	Required
Stop bits will be set to 1.5 when Data bits is	set to 5 bits.
Parity
Setting	Factory Default	Necessity
None, Even, Odd, Space, Mark	None	Required
Flow control
Setting	Factory Default	Necessity
None, RTS/CTS, DTR/DSR, Xon/Xoff	RTS/CTS	Required
FIFO
Setting	Factory Default	Necessity
Enable, Disable	Enable	Required

NPort’s serial ports provide a 16-byte FIFO both in the Tx and Rx directions. Disable the FIFO setting when your serial device does not have a FIFO to prevent data loss during communication.

Interface

Setting	Factory Default	Necessity
NPort 5610-16/8: RS-232 only	RS-232 only	Required
NPort 5630-16/8: RS-422/485 only	4-wire RS-485	Required
NPort 5650-16/8	RS-232	Required

5-10