NPort 5600 Series User’s Manual | Configuring NPort Administrator | |||
| Destination IP address |
|
|
|
| Setting | Factory Default | Necessity |
|
| IP address or Domain Name | blank | Optional |
|
| (E.g., 192.168.1.1) |
|
|
|
| TCP port No. | 4001 | Required |
|
The Pair Connection “Master” will contact the network host that has this IP address. Data will be transmitted through the port No. (4001 by default). Note that you must configure the same TCP port No. for the device server acting as the Pair Connection “Slave.”
Pair Connection Slave Mode
When using Pair Connection Mode, you must select Pair Connection Slave Mode for the Operation mode of one of the NPort 5600 device servers. In effect, this NPort 5600 will be acting as a TCP server.
TCP alive check time
Setting | Factory Default | Necessity |
0 to 99 min | 7 min | Required |
|
|
|
0 min: TCP connection is not closed due to an idle TCP connection.
1 to 99 min: NPort 5600 closes the TCP connection automatically if there is no TCP activity for the given time.
Local TCP port
Setting | Factory Default | Necessity |
TCP port No. (e.g., 4001) | 4001 | Required |
This Port No. must be the same port No. that you set up for the Pair Connection “Master” device server.
