Troubleshooting
The following procedure instructs user to recover once the CAP is unknown.
Step 1. Power off the PC.
OFF
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Step 7. Step 8.
Install jumper onto the JP1 of the board.
Install | jumper |
| |
| JP1 |
Power on the PC.
Now the CAP address of the board will be 0xA700.
ON
Execute
A:> Io-ir q
Enter CAP address 0xA700 to access the board.
Enter the “Configuration Access Port” in HEX: A700 The previous hardware configuration will be shown.
Modify them if necessary. Remember the CAP address this time. Exit the
Power off the PC.
OFF
