4
|
|
| Values for additional control functions | ||
Description | Minimum | Maximum | Standard | ||
P57 | Setting the | Li | Re | Li | |
| • | Li = |
|
|
|
| • | Re = |
|
|
|
Note:
The
•Refer also to the identification plate for these data.
P58 | Setting the fan type. | 0 | 2 | 0 | ||
(Not yet avail- | • | 0 | = Standard. |
|
|
|
able) | • | 1 | = Constant volume. |
|
|
|
| • | 2 | = Constant pressure. |
|
|
|
Note:
The
•Constantvolumeorconstantpressure fans cannot be installed subsequently.
P59 | Enthalpy exchanger installed | 0 (= No) | 1 (= Yes) with | 2 (= Yes) with- |
|
|
| moisture sen- | out moisture |
|
|
| sor | sensor |
Menu P6 Setting additional control functions |
|
| ||
|
|
|
|
|
|
| Values for additional control functions | ||
Description | Minimum | Maximum | Standard | |
P60 | Indicate presence of a | 0 (= No) | 1 (= Yes) | 0 |
| geothermal heat exchanger (GHE). |
|
|
|
P61 | Setting the percentage that the sup- | 0% | 99% | 0% |
| ply air fan must run higher when |
|
|
|
| the valve of the geothermal heat ex- |
|
|
|
| changer (EWT) is open. |
|
|
|
P62 | Tghe, low | 0% | 15% | 7% |
P63 | Tghe, high | 10% | 25% | 23% |
P64 | Tnaheater, desired | 5% | 40% | 18% |
Menu P7 ! Read off malfunctions (and system information)
|
| Values (malfunction) information | ||||
Description | Minimum |
| Maximum |
| Standard | |
P70 | Current software version. | Software version number |
|
| ||
P71 | Last malfunction. | Code corresponding to alarm and malfunction | ||||
|
| display (see section 4.7) |
|
| ||
P72 | Last malfunction but one | Code corresponding to alarm and malfunction | ||||
|
| display (see section 4.7) |
|
| ||
P73 | Last malfunction but two | Code corresponding to alarm and malfunction | ||||
|
| display (see section 4.7) |
|
| ||
P74 | Reset a malfunction on the | 0 | 1 | 0 | ||
|
|
|
|
|
|
32 Instructions for the Installer