COMMUNICATION
Receiving the Emergency Call
If you are on the list as one of the recipients of the emergency call, you should read the following instructions carefully. You should also notify all the persons you will be calling so they know how to react when they receive the emergency call.
The control panel will call you when there are emergencies such as
1.When the phone rings at the calling location, the person who answers the phone will hear a message related to the emergency events, such as “System Panic”, or “Zone 1 Sensor 1 Triggered” etc. This message may be repeated several times depending on how it was programmed.
ADVANCED PROGRAMMING
Follow the procedures below to program the beep / alarm setting.
Step | Keys | Function | Description | Note |
1 | [PROG] | Enter Programming Enter master | 3 beeps for valid password. | |
| [MPIN] | mode | password to | 1 long beep for invalid |
|
|
| programming mode password. | |
|
|
|
|
|
2 | [5] | Select Beep / |
| After [5] is entered, some zone |
Alarm Setting |
| LEDs will flash or stay on. | ||
|
|
| ||
|
|
|
| This indicates whether that |
|
|
|
| zone is set to beep or alarm. |
|
|
|
|
|
3 | Set to Beep: | Select which | Refer to the | If Alarm is set for that zone, |
| [1] to [5] | zone you would | diagram below to | that zone LED will be on. If |
|
| like to Beep or | select the appro- | Beep is set, the LED will |
| Set to Alarm: | Alarm. | priate setting. | flash. You are allowed to |
| [6] to [0]. |
|
| make multiple changes before |
|
|
| terminating programming | |
|
|
|
| |
|
|
|
| mode. |
2.After the message has been repeated for a certain number of times, the control panel will ask for a valid password, you will hear “Enter Password”.
3.Enter the
4.After entering the correct password, you can follow the “Phone Command” instruc- tions to perform the required tasks, such as disarm, turn on / off devices or check the system status etc. For further information of how to control the system remotely, please refer to the next section, "Remote Operation by Telephone".
Zone 1
Sensor 1
Triggered
Enter
Password
4 | [PROG] when | Terminate pro- | PROG LED will be off, and |
| finished. | gramming mode. | you will hear 3 beeps. |
|
|
| ® |
| |
| BEEP | ALARM |
|
| |
Zone 1 | Button [1] | Button [6] | This row | : | |
Zone 2 | Button [2] | Button [7] | Buttons for Beep | ||
Zone LED : Flash | |||||
|
|
| |||
Zone 3 | Button [3] | Button [8] |
|
| |
Zone 4 | Button [4] | Button [9] |
|
| |
Zone 5 | Button [5] | Button [0] | This row | : | |
|
|
| Buttons for Alarm | ||
|
|
| Zone LED : ON | ||
Example:
If you would like to change the setting for zone 5 from “Beep” to “Alarm”, simply press [0] at step 3.
This will change the zone 5 setting to “Alarm”.
