Multi-Link ML-100, ML-001 manual Deactivating the Digital Dialer, Operation, Erase Control Modules

INSTALLATION

Deactivating the Digital Dialer

You can deactivate the digital dialer by erase the phone number memory for central monitoring station.

Step	Keys	Function	Description	Note
1	Press [PROG]	Enter Program-	Enter master	3 beeps for valid
	Press [MPIN]	ming mode	password to	password. 1 long
			programming mode	beep for invalid
				password.
2	Press [1]	Select phone		You will hear:
		number		[Enter Phone
		programming		Memory]
3	Press [0]	Enter phone
		memory
4	Press [ARM]	Confirm delete		You will hear
		the phone		[Phone Zero
		number.		Empty Memory]
				indicating the phone
				number have been
				deleted, the digital
				dialer is deactivated.

Note: If no phone number is programmed to call the central monitoring station, the digital dialer is automatically disabled.

–14–

HOME AUTOMATION

Operation

To turn off a light with the control panel:

1.Press the device number button on the control panel, i.e. pressing 1 will turn off device 1, pressing 2 will turn off device 2.

2.You will hear [Device X Off], where X is the device number.

3.You will also see the PROG LED flashing, indicating the control panel is sending out the wireless signal to control the specific device.

4.If the receiver receives the signal, the control panel will announce [Device Off Accepted].

To turn on a light with the control panel:

1.Press the number below the device number that you would like to turn on, i.e. pressing 6 will turn on device 1, pressing 7 will turn on device 2.

2.You will hear [Device X On], where X is the device number.

3.You will also see the PROG LED flashing, indicating the control panel is sending out the wireless signal to control the specific device.

4.If the receiver receives the signal, the control panel will announce [Device On Accepted].

Erase Control Modules

To erase a control module from the control panel, it is similar to learning a control module, which involves 2 parts.

1.Erase the memory of the control panel

2.Erase the memory of the control module

Part 1 Erase the memory of the Control Panel

Step	Keys	Function	Description	Note
1	[PROG]	Enter	Enter master	3 beeps for valid
	[MPIN]	Programming	password to	password. 1 long beep
		mode	programming mode	for invalid password.
2	[0]	Select erase		After [0] is entered, some
		control		zone LEDs will flash or
		module		stay off. The zone LEDs
		programming		represent whether that zone
				is occupied by any control
				module. **See Table F
3	To erase an	Select the	Refer to the table	After you have selected the
	occupied	control module	below to select	remote location, you will
	control module,	location you	the control	hear 3 beeps and verbal
	press [1] to [5].	would like to	module location.	confirmation [Device X
		erase		Empty Memory], where
				X is the control module
				location you have selected.

–43–