COMMUNICATION
Table 1: Remote Phone Operations
SYSTEM OPERATION | PHONE COMMAND | DESCRIPTION |
|
|
|
Turn on device x | x+[*] | Turn devices on will hear [Device X On]. When the |
[x] = 1 to 5 |
| control module receives the on signal, it will turn on the |
|
| plugged in device, and send a confirmation back to the |
|
| control panel. You will then hear [Device On Accepted]. |
|
|
|
Turn off device x | x+[#] | Turn devices off will hear [Device X Off]. When the |
x = [1 to 5] |
| control module receives the off signal, it will turn off the |
|
| plugged in device, and send a confirmation back to the |
|
| control panel. You will then hear [Device Off Accepted]. |
|
|
|
Check system status | [8]+[#] | You will hear system status announcement |
|
|
|
Arm | [7]+[#] | You will hear [System Armed] |
|
|
|
Disarm | [9]+[#] | You will hear [System Disarmed] |
|
|
|
Disconnect | [0]+[#] | Phone line disconnect |
|
|
|
ADVANCED PROGRAMMING
Advanced Programming allows users to customize the control panel to react differently under different conditions. Features such as:
-When a sensor is triggered, the control panel can beep or alarm
-Beeping can be terminated automatically after a fixed period of time for some sensors
-Some sensors can be programmed to beep only, never alarm
-When a door is open, turn lights on
-Program additional sensors and remotes
Programming Summary
COMMAND | DESCRIPTION |
|
|
[PROG] + [1] | Program Phone Numbers |
|
|
[PROG] + [2] | Program Password |
|
|
[PROG] + [3] | Learn Sensors |
|
|
[PROG] + [4] | Learn Keychain or Keypad Transmitters / Control Modules |
|
|
[PROG] + [5] | Beep / Alarm Setting |
|
|
[PROG] + [6] | Auto Mute Setting |
|
|
[PROG] + [7] | Event Trigger Setting |
|
|
[PROG] + [8] | Alert Zone (Bypass) Setting |
|
|
[PROG] + [9] | Erase Sensors |
|
|
[PROG] + [0] | Erase Keychain or Keypad Transmitters / Control Modules |
|
|
Follow the instructions below to have access to Advanced Programming.
Beep / Alarm
User can customize the audio warning so that when a sensor is triggered, the control panel may beep or alarm may sound instantly. Depending on whether the control panel is armed or disarmed, the audio warning is different.
System Disarmed (Alert Mode)
If a zone is set to “Beep”, the control panel will beep when a sensor is triggered, until the sensor is deactivated. Motion Sensor activation will not cause any beeping unless the zone for the motion sensor is programmed as a "Bypass Zone" (see page 33).
If a zone is set to “Alarm”, alarm will sound instantly when a sensor is triggered. Alarm will stop when the sensor is deactivated, or reaches a
