MultiVOIP FX User Guide

Overview

 

 

LED Descriptions for MultiVOIP-FX2 Units

Front Panel LED Definitions

LED NAME

DESCRIPTION

General Operation LEDs (one set on each MultiVOIP model)

Power

Indicates presence of power.

 

 

Boot

After power up, the Boot LED will be on briefly while the

 

MultiVOIP is booting. It lights whenever the MultiVOIP is

 

booting or downloading a setup configuration data set.

Ethernet

FDX. LED indicates whether Ethernet connection is

 

half-duplex or full-duplex (FDX) and, in half-duplex

 

mode, indicates occurrence of data collisions. LED is

 

on constantly for full-duplex mode; LED is off

 

constantly for half-duplex mode. When operating in

 

half-duplex mode, the LED will flash during data

 

collisions.

 

LNK. Link/Activity LED. This LED is lit if Ethernet

 

connection has been made. It is off when the link is

 

down (i.e., when no Ethernet connection exists).

 

While link is up, this LED will flash off to indicate data

 

activity.

 

SPD. Data speed indicator. When lit, data rate is

 

100 Mbps. When not lit, data rate is 10 Mbps.

 

COL. Collision indicator. Lit when data

 

collision is detected on Ethernet network.

 

 

Channel-Operation LEDs

Voice/Fax 1

On MVPFX2-2 only. This indicator is lit when there is

 

call activity on Channel 1. If the voip channel is

 

operating as FXS, the LED is ON when the device

 

attached to the channel is off hook. If the voip channel

 

is operating as FXO, the LED is ON when the voip has

 

seized the line.

 

 

Voice/Fax 2

On MVPFX2-2 only. This indicator is lit when there is

 

call activity on Channel 2. If the voip channel is

 

operating as FXS, the LED is ON when the device

 

attached to the channel is off hook. If the voip channel

 

is operating as FXO, the LED is ON when the voip has

 

seized the line.

 

 

1, 2, 3, ... 8

On MVPFX2-4 and MVPFX2-8. There is one LED for

 

each voip channel. The indicator for any channel is lit

 

when there is call activity on that voip channel. If the

 

voip channel is operating as FXS, the LED is ON when

 

the device attached to the channel is off hook. If the

 

voip channel is operating as FXO, the LED is ON

 

when the voip has seized the line.

 

 

11

Page 11
Image 11
Multi-Tech Systems MVPFX2-2 manual Description, Channel-Operation LEDs