Safety Information
TrOwEL SafETy
daNgEr
Engine fuel exhaust gases contain poisonous carbon monoxide. This gas is colorless and odorless, and can cause death if inhaled.
The engine of this equipment requires an adequate free fl ow of cooling air. NeveR operate this equipment in any enclosed or narrow area
where free fl ow of the air is restricted. If the air fl ow is
restricted it will cause injury to people and property and serious damage to the equipment or engine.
NeveR operate the equipment in an explosive atmosphere or near combustible materials.An explosion or fi re could result causing severe bodily harm or even death.
warNiNg
aLwayS keep clear of rotating or moving
parts while operating the trowel.
dO NOT start or operate the trowel if the drive train will not disengage. Centrifugal
force between the trowel and surface when starting can cause uncontrolled handle movement that can cause serious injury. The handle must not move while pulling the engine recoil starter.
NeveR disconnect any emergency or safety devices.
These devices are intended for operator safety. Disconnection of these devices can cause severe injury, bodily harm or even death. Disconnection of any of these devices will void all warranties.
CaUTION
NeveR stand on trowel during operation.
NeveR lubricate components or attempt service on a running machine.
NeveR place your feet or hands inside the guard rings while starting or operating this equipment.
NOTICE
aLwayS keep the machine in proper running condition.
Fix damage to machine and replace any broken parts immediately.
aLwayS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children and unauthorized personnel.
A safety manual for operating and maintenance personnel of concrete power trowels produced by the Association of Equipment Manufacturers (AEM) can be obtained for a fee by ordering through their website at www.aem.org.
Order FORM PT-160
ENgiNE SafETy
warNiNg
dO NOT place hands or fingers inside engine compartment when engine is running.
NeveR operate the engine with heat shields or guards removed.
Keep fi ngers, hands hair and clothing away 
from all moving parts to prevent injury.
dO NOT remove the engine oil drain plug
while the engine is hot. Allow the oil to cool before performing maintenance. This will prevent scalding of personnel.
CaUTION
NeveR touch the hot exhaust manifold, muffl er or cylinder. Allow these parts to cool
before servicing equipment.
NOTICE
NeveR run engine without an air fi lter or with a dirty air fi lter. Severe engine damage may occur. Service air fi lter frequently to prevent engine malfunction.
NeveR tamper with the factory settings of the engine or engine governor. Damage to the engine or equipment can result if operating in speed ranges above the maximum allowable.
BS46H SERIES
