Centrifugal Safety "STOP" Switch
This trowel has been equipped with a centrifugal safety "STOP" switch (Figure 18). This switch should be tested every time the engine is started.
The switching mechanism of this switch should operate freely and should always be kept in this condition. With the switch in the OFF position, the engine should not start or run. The purpose of this switch is to stop the engine in a runaway situation, (i.e. the operator releasing the handle during operation).
OFF
ON
CENTRIFUGAL
SAFETY “STOP”
SWITCH
Figure 18. Centrifugal Safety "STOP" Switch
Operation
This section is intended to assist the operator with the initial
Lifting the Trowel Onto a Slab
Extra care should be taken when lifting the trowel off the ground. Serious damage to the machine or personal injury could be caused by dropping a trowel.
WARNING
NEVER attempt to lift this machine alone. NEVER lift the trowel by the guard ring as it may rotate and cause injury.
ALWAYS make certain the handle is secure and use only the manufacturer's approved lifting point. The trowel may be lifted at the center lifting bale by crane or other lifting device of adequate capacity.
inspection/operation
NOTICE
DO NOT attempt to operate the trowel until the Safety, General Information and Inspection sections of this manual have been read and thoroughly understood.
NOTICE
The trowel is heavy and awkward to move around. Use proper heavy lifting procedures and DO NOT lift the trowel by the guard rings.
Lifting Bale
The lift bale provides an optimal lift point for lifting the trowel. When lifting the trowel onto a concrete slab, attach a chain or rope to the lifting bale. Make sure the lifting device has adequate lifting capacity to lift the trowel.
Using a crane or forklift (Figure 19) to lift the trowel is highly recommended, and is perfectly safe for the trowel. ALWAYS use extra care when lifting the trowel off the ground.
LIFT
