|
|
| troubleshooting |
|
|
|
|
|
|
|
|
| Troubleshooting |
| |
Symptom | possible problem |
| Solution |
|
|
|
|
| Engine ON/OFF Switch in "OFF" position |
| Make sure that the Engine ON/OFF Switch is ON |
| or malfunctioning? |
| or replace switch if necessary. |
| Centrifugal ON/OFF Switch in "OFF" |
| Place centrifugal stop switch in "ON" position. |
| position or malfunctioning? |
| Check wiring. Replace switch if necessary. |
|
|
|
|
|
|
| Look at the fuel system. Make sure there is fuel |
Engine running rough or not at all. | Fuel? |
| being supplied to the engine. Check to ensure that |
|
|
| the fuel fi lter is not clogged. |
| Ignition? |
| Check to ensure that the ignition switch has power |
|
| and is functioning correctly. | |
|
|
| |
|
|
|
|
| Loose wire connections |
| Check wiring. Replace or repair as necessary. |
|
|
|
|
| Bad contacts in ON/OFF switch? |
| Replace ON/OFF switch. |
|
|
|
|
|
|
| Make certain blades are in good condition, not |
|
|
| excessively worn. Finish blades should measure |
| Blades? |
| no less than 2"" (50mm) from the blade bar to |
|
| the trailing edge, combo blades should measure | |
|
|
| |
|
|
| no less that 3.5"" (89mm). Trailing edge of blade |
|
|
| should be straight and parallel to the blade bar. |
|
|
| Check that all blades are set at the same |
| Pitch adjustment? |
| pitch angle as measured at the spider. A fi eld |
|
| adjustment tool is available for height adjustment | |
|
|
| |
|
|
| of the trowel arms. (Contact Parts Dept.) |
|
|
| Check the spider assembly for bent trowel arms. |
| Bent trowel arms? |
| If one of the arms is even slightly bent, replace it |
Trowel bounces, rolls concrete, or makes |
|
| immediately. |
|
|
| |
uneven swirls in concrete. |
|
| Check fi t of arms in spider. This can be done by |
| Spider? |
| moving the trowel arms up and down. If there is |
|
| more than 1/8 inch (3.2 mm) of travel at the tip of | |
|
|
| |
|
|
| the arm, the spider and arms should be replaced. |
|
|
|
|
|
|
| Check the fl atness of the thrust collar by rotating |
| Thrust collar? |
| it on the spider. If it varies by more than 0.02 inch |
|
|
| (0.5 mm) replace the thrust collar. |
|
|
|
|
|
|
| Check the thrust collar by rocking it on the spider. |
| Thrust collar bushing? |
| If it can tilt more than 3/32 inch (2.4 mm) - as |
|
| measured at the thrust collar O.D., replace the | |
|
|
| |
|
|
| thrust collar. |
|
|
|
|
| Thrust bearing worn? |
| Check the thrust bearing to see that it is spinning |
|
| freely. Replace if necessary. | |
|
|
| |
|
|
|
|
page 40 — BS46H SERIES
