GENERAL INFORMATION

FAMILIARIZATION

Generator

The Multiquip DA7000 Series generators are 6.0 kW (continuous output), 7.0 kW (max output) A.C. generators designed as a portable dual purpose power source for 60 Hz (single phase) lighting facilities, power tools, submersible pumps and other industrial and construction machinery.

Control Panel

The control box is provided with the following:

GFCI 120 volt receptacle, 20 amp (single-phase)

120 volt receptacle, 25 amp (single-phase)

120/240 volt receptacle, 25 amp (single-phase)

120/240 volt receptacle, 25 amp (single-phase)

AC Voltmeter

Main Circuit Breaker 265V @25 Amps

GFCI Circuit Breaker 120V @20 Amps

Idle Control Switch

Starter Switch

Warning Lamp Unit

Hour Meter

Ground Terminal

Engine Protection System

Engine protection fail safe features are provided in the event of low oil pressure, high coolant temperature and failure of the battery to charge. If any of the above conditions occur while operating the generator it will cause a complete unit shut down.

Oil Pressure Warning Alarm

This unit is equipped with a protective device that detects low oil pressure. If the lubricating oil pressure of this unit should become abnormally low, the protective device will automatically stop the engine. If this condition should occur, please refer to the engine troubleshooting table in this manual.

Idle Control Switch

The DA7000 series generators are provided with an automatic idle (engine) control capability for noise suppression and fuel cost reduction. The automatic idle control feature automatically engages under a no-load condition.

With AC loads of more than 150W (such as lighting equipment, motor-powered tools, submersible water pumps, etc.), the engine runs at high speed.When a no load condition is produced, the engine automatically slows down.

Turn the idle control switch to the “ON” (up) position when AC loads of more than 150W are connected. Turn the idle control switch to the “OFF” (down) position when AC loads of less than 100W or when a magnetic switch is used.

Excitation System

The DA7000 series generators use a brushless exciter to create rated output electricity. This system will use the mechanical energy generated by the 3600 RPM engine to spin the rotor (or armature) inside the generator (or alternator end).

Excitation current is sourced from the battery to the excitation windinding in the stator. Current applied to this coil creates a magnetic fi eld. The rotating armature is induced with AC current.

Battery Charge Alarm

This unit is equipped with a protective device that signals an alarm and automatically stops the engine when the battery cannot be charged by the alternator.

Water Temperature Alarm

This unit is equipped with an apparatus that signals an alarm and automatically stops the engine when the cooling water temperature becomes abnormally high. This apparatus will not function properly if the machine is operated with less than the proper amount of coolant.

Engine

The DA7000 series generators are powered by a water- cooled, 4-cycle KUBOTA diesel engine. This engine is designed to meet every performance requirement of the generator. Reference Table 2, engine specifications.

In keeping with Multiquip's policy of constantly improving its products, the specifications quoted herein are subject to change without prior notice.

Figure 3 and Figure 4 show the basic controls and indicators for the DA7000 series generators.

PAGE 18 — DA7000 SERIES GENERATORS• OPERATION AND PARTS MANUAL — REV. #5 (01/20/11)

Page 18
Image 18
Multiquip DA7000WGH, DA700SSW manual General Information, Familiarization

DA700SSW, DA7000WGH specifications

The Multiquip DA7000WGH and DA700SSW are exceptional diesel-powered generators designed to deliver reliable power across a variety of demanding applications. Known for their durability and efficiency, these generators are ideal for construction sites, events, and backup power needs.

The DA7000WGH model features a robust 7000-watt output, making it suitable for heavy-duty tasks. It is powered by a water-cooled, four-cylinder diesel engine, which not only ensures longer operational life but also minimizes noise levels during use. The generator is equipped with a heavy-duty steel frame that provides superior protection against the rigors of job site environments. Additionally, its compact design allows for easy transport and maneuverability, making it a practical choice for contractors and event organizers alike.

In terms of technology, the DA7000WGH includes advanced digital instrumentation. An intuitive control panel offers easy access to critical information such as voltage, frequency, and operating hours. This feature allows users to monitor the generator's performance effectively, ensuring optimal operation and preemptive maintenance. Moreover, the generator boasts an integrated fuel gauge and an automatic low oil shut-off feature that enhances both safety and longevity.

On the other hand, the DA700SSW model presents an equally impressive set of features tailored for those requiring a quieter operation. Utilizing a sound-attenuated enclosure, it significantly reduces noise levels without sacrificing power output. This makes the DA700SSW an excellent choice for outdoor events, festivals, and applications where noise restrictions may apply.

Both models incorporate a heavy-duty alternator designed to provide clean and stable power, critical for sensitive electronics. The generators are also equipped with multiple output options, including 120V and 240V outlets, ensuring versatility for a range of equipment and tools.

In conclusion, the Multiquip DA7000WGH and DA700SSW generators stand out for their combination of power, durability, and advanced technology. Whether you require a rugged workhorse for a construction project or a quieter model for an outdoor event, these generators deliver reliable performance tailored to meet various demands. With their advanced features and easy transportability, they represent a smart investment for anyone in need of dependable power solutions.