Table of Contents
DCA-100SSJU — CONTROL PANEL
The definitions below describe the controls and functions of the DCA-100SSJU " Control Panel " (Figure 8).
1.Main Circuit Breaker – This three-pole, 250 amp main breaker is provided to protect the UNV voltage output terminals from overload.
2.AC Ammeter – Indicates the amount of current the load is drawing from the generator.
3.Ammeter Change-Over Switch – This switch allows the AC ammeter to indicate the current flowing to the load connected to any phase of the output terminals, or to be switched off.
4.Voltmeter Change-Over Switch – This switch allows the AC voltmeter to indicate phase to phase voltage between any two phases of the output terminals or to be switched off.
5.Voltage Regulator Control – Allows manual adjustment of the generator’s output voltage.
6.Frequency Meter – Indicates the output frequency in hertz (Hz). Normally 60 Hz ±1 Hz .
7.AC Voltmeter – Indicates the single phase output voltage present at the UNV terminals.
DCA-100SSJU — PARTS AND OPERATION MANUAL (STD)— REV. #2 (05/03/01) — PAGE 29
