Multiquip DCA-100SSJU— GENERATOR SHUTDOWN PROCEDURE, Table of Contents, Engine Shutdown

Table of Contents

DCA-100SSJU — GENERATOR SHUTDOWN PROCEDURE

ENGINE SHUTDOWN

To shutdown the generator, use the following procedure:

1.Switch both the MAIN, GFCI and LOAD circuit breakers (Figure 66) to the “OFF” position.

6.If the engine is equipped with the engine throttle lever, turn the key to ‘’STOP’ position (Figure 70).

Figure 66. Main, GFCI and Load circuit breakers

Figure 70. Engine Starter Switch (STOP)

7. Remove the load from the UNV terminal strip.

2.Set the engine speed switch (Figure 67) to the idle (low) position.

Figure 67. Engine Speed Switch

3.If the engine is equipped with the engine throttle lever, turn and push to ‘IDLE’ position (Figure 68).

Figure 68. Engine Throttle Lever (IDLE)

4.Let the engine cool by running it for 3-5 minutes with no load applied.

5.Turn the Auto-Off/Reset-Manual switch from the MPEC to “OFF/Reset” position (Figure 69).

Figure 69. Off/Manual Auto Switch

DCA-100SSJU — PARTS AND OPERATION MANUAL (STD)— REV. #2 (05/03/01) — PAGE 53