Multiquip operation manual DCA-600SSV Generator Control Panel

DCA-600SSV — GENERATOR CONTROL PANEL

12

3	4	5	14
			AUTO	MANUAL
			OFF/RESET
HZ	A	V	LOW OIL PRESSURE
			HIGH COOLANT TEMPERATURE
			OVERCRANK
			OVERSPEED
			ENGINE RUNNING
			MOOOOO-20001Q

67

8 9

10 11

12 13

Figure 6. Generator Control Panel

The definitions below describe the controls and functions of the DCA-600SSV " Control Panel " (Figure 6).

1.Pilot Lamp – Indicates that the generator is working properly.

2.Panel Light – Normally used in dark areas or at night time.When activated, panel lights will illuminate.When lit this light will make it easier to read the meters and gauges. When the generator is not in use be sure to turn the panel light switch to the OFF position.

3.Frequency Meter – Indicates the output frequency in hertz (Hz). Normally 60 Hz ±1 Hz .

4.AC Ammeter – Indicates the amount of current the load is drawing from the generator.

5.AC Voltmeter – Indicates the single phase output voltage present at the UVWO terminals. .

6.Ammeter Change-Over Switch – This switch allows the AC ammeter to indicate the current flowing to the load connected to any phase of the output terminals, or to be switched off.

7.Voltmeter Change-Over Switch – This switch allows the AC voltmeter to indicate phase to phase voltage between any two phases of the output terminals or to be switched off

8.Panel Light Switch – When activated, this switch will turn on the luminate the control panel.

9.Voltage Regulator Control – Allows manual adjustment of the generator’s output voltage

PAGE 22 — DCA-600SSV — OPERATION AND PARTS MANUAL — REV. #0 (07/13/09)