Multiquip DCA-600SSV - MAINTENANCE, Inspection/Maintenance, General Inspection, Air Cleaner

DCA-600SSV — MAINTENANCE

	TABLE 14. INSPECTION/MAINTENANCE			10 Hrs	250 Hrs	500 Hrs	1000 Hrs
				DAILY
		Check Engine Fluid Levels		X
		Check Air Cleaner		X
		Check Battery Acid Level		X
		Check Fan Belt Condition		X
		Check for Leaks		X
		Check for Loosening of Parts		X
		Replace Engine Oil and Filter * 1			X
	ENGINE	Clean Air Filter			X
		Check Fuel Filter/Water Seperator Bowl		X
		Clean Unit, Inside and Outside			X
		Change Fuel Filter				X
		Clean Radiator and Check Coolant Protection Level*2				X
		Replace Air Filter Element * 3				X
		Check all Hoses and Clamps * 4					X
		Clean Inside of Fuel Tank					X
	GENERATOR	Measure Insulation Resistance Over 3M ohms			X
		Check Rotor Rear Support Bearing				X
		*1	Replace engine oil anf filter at 100 hours, first time only.
		*2	Add "Supplemental Coolant Addatives (SCA'S)" to recharge the engine coolant.
		*3 Replace primary air filter element when restriction indicator shows a vaccum of 625 mm (25 in. H20).
		*4	If blowby hose needs to be replaced, ensure that the slope of the bloby hose is at least a 1/2 inch per foot, with
			no sags or dips that could collect moisture and/or oil.
General Inspection
Prior to each use, the generator should be cleaned and
inspected for deficiencies. Check for loose, missing or
damaged nuts, bolts or other fasteners. Also check for fuel,
oil, and coolant leaks.Use Table 14 as a general maintenance
guideline Engine Side (Refer to the Engine Instruction
Manual)
Air Cleaner
Every 250 hours: Remove air cleaner element (Figure 68)
and clean the heavy duty paper element with light spray of					Figure 68. Air Cleaner/Indicator

compressed air. Replace the air cleaner as needed.
Air Cleaner with Dust Indicator		The air filter should not be
This indicator (Figure 65) is attached to the air cleaner.When	NOTE
		changed until the indicator reads
the air cleaner element is clogged, air intake restriction
		“RED”. Dispose of old air filter it
becomes greater and the dust indicator signal shows RED
		may not be cleaned or reused.
meaning the element needs changing or service. After
changing the air element, press the dust indicator button to
reset the indicator.

PAGE 44 — DCA-600SSV — OPERATION AND PARTS MANUAL — REV. #0 (07/13/09)