Multiquip DCA180SSJU operation manual Auxiliary Gage Fault

DIAGNOSTIC DISPLAY

2.The main menu will pop up on the display. Use the “Arrow Buttons” to scroll through the menu until the

“Engine	Configuration” menu item has been
highlighted.

GO TO 1-UP DISPLAY

STORED CODES

ENGINE CONFG

SETUP 1-UP DISPLAY

SETUP-4-UP DISPLAY

SELECT UNITS

ADJUST BACKLIGHT

FAULTS AND WARNINGS

Auxiliary Gage Fault

1.During normal operation the single or four parameter screen will be displayed.

				98%	1000 RPM
0			3000
	1500			LOAD RPM	ENG RPM
	1800 RPM
		COOL TEMP		14.2	57 PSI
ENG RPM				BATT VOLT	OIL PRES

3. Once the “Engine Configuration” menu item has been
highlighted touch the “Enter Button” to view the engine	2.	The PVA Series of auxiliary gages can be attached to
configuration data.		the PowerView. These auxiliary gages communicate
GO TO 1-UP DISPLAY		with the Modbus master PowerView via a daisy-chained
STORED CODES		RS-485 port. If at any time during system initialization
SETUP 1-UP DISPLAY
ENGINE CONFG

SETUP-4-UP DISPLAY	or normal operation an auxiliary gage should fail, the
SELECT UNITS
ADJUST BACKLIGHT	single or four parameter screen will be replaced with
	the “MLink Gage Fault” message.
	1 of x

4.Use the “Arrow Buttons” to scroll through the engine configuration data.

ENGINE SPEED PT 1

1800 RPM

ENGINE OIL PRESSURE

GAGE NOT RESPONDING

HIDE

MORE

5.Touch the “Menu Button” to return to the main menu.

ENGINE SPEED PT 1

1800 RPM

MORE

6.Touch the “Menu Button” to exit the Main menu and return to the engine parameter display.

3.To acknowledge and “Hide” the fault and return to the single or four parameter display, touch the “Enter

Button”.

1 of x

ENGINE OIL PRESSURE

GAGE NOT RESPONDING

HIDE

4.The display will return to the single or four parameter

screen.

				!	98%		1000 RPM
0	1500		3000		LOAD RPM		ENG RPM
	1800 RPM					!
					14.2		57 PSI
ENG RPM		COOL TEMP!			BATT VOLT		OIL PRES	!

DCA-180SSJU — OPERATION AND PARTS MANUAL — REV. #3 (02/01/10) — PAGE 25