Multiquip DCA180SSJU operation manual Connecting Loads, Output Terminal Panel Familiarization

OUTPUT TERMINAL PANEL FAMILIARIZATION

Connecting Loads

Loads can be connected to the generator by the

or the convienience receptacles (Figure 14). Make sure to read the operation manual before attempting to connect a load to the generator.

To protect the output terminals from overload, a

3-pole, 500A circuit breaker is provided. Make sure to switch ALL circuit breakers to the OFF position prior to starting the engine.

Over Current Relay
An	(Figure 15) is connected to the main

circuit breaker. In the event of an overload, both the circuit breaker and the over current relay may trip. If the circuit

breaker can not be reset, the on the over cur- rent relay must be pressed. The over current relay is located in the control box.

Figure 15. Over Current Relay

Figure 14. Connecting Loads

PAGE 42 — DCA-180SSJU — OPERATION AND PARTS MANUAL — REV. #3 (02/01/10)