Basic Operation
Page 20 | WI1424A 1/06 |
BASIC OPERATION
This section provides a brief overview of system operation. For detailed operation, refer to the User's Guide furnished with the keypad (see page 7 for a listing of User Guides for each keypad) and to the Keypad Programming Modes at the end of this manual. NOTE: Keypad displays shown in this text are for the
USER CODES & ZONE DESCRIPTIONS
(Refer to the
Default User Code.
The first code programmed should replace the default (User 01) code, “U01 123 • • • - • • - • • ”, (1,2,3), which should not be selected as a user code.
Each user should be assigned his own dissimilar code and should be cautioned against divulging his code to anyone else. Thus should it become necessary to remove a user from the system, that one code may be cancelled without affecting other codes, and that user would then be prevented from entry. Note: Duplicate User Codes are not allowed
by the panel; therefore a duplicate Code entered in the LCD Window will erase when Uor Dis pressed.
Changing or Canceling a User Code
To change any user code, merely program over the existing user code as described in the Programming Instructions. Similarly, to cancel a user code, blank out each number of the user code.
Arm/Disarm Code (Programmable in Dealer Program Mode only)
An Arm/Disarm Code may be used to arm/disarm the area in which it is programmed. Up to 6 digits may be programmed or it may be programmed as a
An
Service Code (Programmable in Dealer Program Mode only)
A Service Code is an Arm/Disarm Code that is easily activated when needed, and dormant at other times. Intended for the occasional or temporary user (repairman, etc.) who would otherwise be denied access to the premises. It may then be used to arm and disarm just as any other User Code. A Service Code can be armed/disarmed from a disarmed state, but it cannot be armed/disarmed from an armed state, after another user code has been entered. Up to 6 digits may be programmed or it may be programmed as a
Access Code
The Access Code will trip the panel's PGM2 Output Relay while armed or disarmed if the “Access Control on PGM2 Output” and “PGM2 Output Access Control Time” is programmed. The Access Code is programmed as any other user code, but without arm/disarm capability. Note: These systems have not been investigated by UL for compliance with UL294 (Access Control Systems).
Ambush Code
The Ambush Code is special user code entered by the user typically to cause a silent report to be sent to the central station. Thus, should the user be forced to disarm by an assailant, he can silently signal an emergency while appearing to be merely disarming the panel. (Check the glossary for programming required to enable this feature).
Zone Descriptions (GEM-RP1CAe2/GEM-K1CA only)
Zone descriptions follow the Program Code in the normal programming sequence. Program the description, up to two lines, letter by letter. Enter an identifying description for each zone. Characters are selected by pressing keypad but- tons multiple times, "Cell Phone" style. Buttons 1through 9plus 0and Gare used. Press [Aor
R] to move cursor right, press [B] to move cursor left.
To advance to the next zone (or to any other zone), move the cursor to the displayed zone number (i.e., “01”) using
X | LNAPCO Security Systems |
