Napco Security Technologies GEM-P1664 Keypad Configuration Mode, Exit C7890G, R123 D E, B456 FNo

Page 52

KEYPAD CONFIGURATION MODE

Scroll Down	NEXT/YES	Yes
	B456A123 D FEPRIOR/NO
Scroll Up		No

AREA

Exit C7890G

For "Classic" Keypads

Scroll Down

Scroll Up

Exit

WI1424A 1/06

NEXT/YES Yes

R123 D E

PRIOR/NO

B456 F No

AREA

C7890G

For "K Series" Keypads

Keypad Programming Modes: Keypad Configuration Mode

GEM-RP1CA/1CAe/1CAe2/

GEM-K1CA KEYPADS

Move Jumper JP1 * from Pins 1-2 to Pins 2-3

(Wait about 15 seconds: “OUT OF SYSTEM”)

Enter Factory Code:

11123

Press R(or A) button

Configure:

•Keypad Beep ON/OFF

•Entry Sounder

•Keypad Address 01

•New Compat# 000 **

Press Cbutton

(“01 OUT OF SYSTEM”)

Return Jumper JP1 * from Pins 2-3 to Pins 1-2

(“SYSTEM READY”)

*JP1 is located at the top center of the circuit board.

**Not available in the GEM-P1664.

GEM-RP2AS/RP2ASe/RP2ASe2

KEYPADS

Configure:

•Keypad Address (Jumpers J1-J3)

•Touchpad Backlight (Jumper A)

•LCD Backlight (Jumper B)

X GEM-P1664 Installation Instructions LNAPCO Security Systems