Page 56 | WI1424A 1/06 |
10.Alarm and Pulse Alarm
11.Chime is set to 2 seconds.
12.Change Pulse Alarm to Cadence Alarm is enabled.
13.Auto Reset after Burglary Output Timeout is enabled.
If the answer to the question “Enable
1.Auto Reset and Swinger Shutdown are removed from burg zones.
2.
3.
4.
5.
6.
7.
8.
9.
10.1417 "Abort Delay" is changed to 30 seconds.
11.Cancel Time ("Cancel Window Duration") is set to 7 minutes.
Subsequent entering of the Dealer Program allows only a subset of the Easy Program Menu which does not include the ques- tion “Enable
Note: When address 2053 "Enable
Out of Box Panel Operation (Prior to CP-01 Changes)
The following describes the control panel factory defaults that are loaded if you enter the Dealer Program Menu, which is also the factory default used with these panels prior to modifications made in order to comply with the
The program has minimum defaults, programmed with 8 hardwire zones (Zones
1)Default User 1 Code = "123" and enabled as an Arming Code in Area 1.
2)Dealer Program Default Code = "456789".
After powering up, the installer is required to enter Program Mode using the Dealer Program Default Code of "456789".
The Easy Program mode that is entered is a series of questions regarding the required functions of the particular installation. After exiting the Easy Program Mode, the installer could complete the installation. Subsequent entering of Dealer Program Mode allows only a subset of the Easy Program menu that prevents the existing program from being deleted, but allows the system to be expanded.
X | LNAPCO Security Systems |